ASI 1044 Panduan Pengoperasian dan Servis - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Servis untuk Peralatan gigi ASI 1044. ASI 1044 20 halaman. Dental operative unit classic assistant’s cart

Halaman Cetak

laSSic

6.0 SeRvice

6.1

Repair Service and Replacement Parts

In the event you require assistance with the set-up, operation or maintenance of your system, please call (800) 566-9953 or

(303) 766-3646 and speak with one of our Customer Service Representatives. Our service hours are from 8:00 a.m. to 4:30

p.m., in Colorado which is on Mountain Standard Time, Monday through Friday.

In many instances, service problems may be solved over the telephone. When requesting service, please have the following

information ready:

• Product / Model Number

• Date of Manufacture

• Serial Number of affected unit

This information can be found on the back of cart units. If service is required, you may need a service technician to go to your

office or have the unit sent to us for service. Please refer Storage/Shipping for instructions before shipping the unit.

Warranty service will be performed in accordance with ASI's Warranty. Non warranty service will be provided at reasonable

parts and labor costs.

Replacement Parts

New or replacement parts may be ordered directly from ASI online or by telephone. To place an order, please contact our

Customer Service Department 8:00 a.m. to 4:30 p.m. MST:

Online:

http://asimedical.net/store/

Toll Free:

(800) 566-9953

Tel:

(303) 766-3646

Fax:

(303) 565-8929

6.2

Basic Service and Access

Service of the system is to be done only by qualified technicians who are aware of electrical and compressed air precautions.

6.3

Delivery System

For general maintenance and service, please refer to website for downloads of technical guidelines and videos.

6.3.1 Adjusting Handpiece Pressure

Drive air pressures for handpieces are pre-set at the factory to the recommended operating pressures for handpieces.

The handpiece pressure adjustments are small set screws or knobs located on the side panel of the system and

will be labeled with abbreviations for the type of instrument installed as follows:

FHS - Fiber Optic High Speed (air driven)

HS - High Speed (air driven)

LS - Low Speed (air driven)

US - Ultrasonic

Adjustment screws for electric instruments should be left in a fully open position to allow free air flow to pressurize and

exhaust off of the air/electric switches. Knobs are placed on adjustment screws to allow easier adjustment of operating air

pressures for air operated high and low speed handpieces.

To adjust the drive air pressure for each handpiece, perform the following steps:

1. Remove the handpiece from its holder. A handpiece must be connected to the tubing in order to register pressure on the

gauge.

2. Depress the foot control and read the handpiece pressure gauge on the front of the unit.

3. Rotate the handpiece air adjustment (clockwise to decrease, or counter-clockwise to increase pressure) until the desired air

pressure range is achieved, as specified by the handpiece manufacturer's instructions.

Rev.A

ASI - The leader in Advanced Systems Integration www.asimedical.net

1044/1045/2044/2045

dvanced

anual