Cyrus dAD3 Petunjuk Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Pemutar CD Cyrus dAD3. Cyrus dAD3 6 halaman.

Halaman Cetak
Cyrus dAD3

TROUBLESHOOTING GUIDE

If your Cyrus dAD3 is not operating properly, disconnect the power and
check all connections using the notes in this handbook. If problems
persist, the checklist below may help.
If you are in any doubt, consult your dealer.
Disc Spinning with no sound
Switch off the power to the audio system and check that connections have
been correctly made from the Cyrus dAD3 to the amplifier.
If used with another D/A converter, check the connection from the
'DIGITAL OUT' socket of the Cyrus dAD3 to the D/A converter. Check
also that power is applied to the D/A converter and amplifier and that the
input selection and volume control of these units is correctly set.
Pause may have been set. Check for the pause symbol on the display.
Press the PLAY/PAUSE key again on the front panel or handset to cancel
pause.
Skipping tracks or distorted sound
The disc may be dirty or badly scratched. Try playing another disc. If the
other disc plays ok, try cleaning the 1
Indication 'EO' on the display (Error: Operating)
A function has been selected which is not available.
Indication 'EP' on the display (Error: Programming)
An incorrect key sequence has been used during programming.
Indication 'Ed' on the display (Error: Disc)
The disc will not read. It may be dirty or defective.
No display
The display may have been switched off at the handset. Press the display
key again to restore the display and backlight.
No Remote Operation
The handset batteries may need to be replaced:
Remove the battery compartment cover located underneath the unit.
Remove the batteries and replace with new ones carefully noting the
orientation marked in the bottom of the battery case.
The batteries in the unit should only be replaced with new batteries type
AAA (I.E.C.L R03).
4
disc.
st

Laser Product

This label on the rear panel tells
you that the unit contains a Laser
component. Opening this unit will
expose the user to radiation from
the laser beam.

WARRANTY

The warranty card enclosed should be completed by the Dealer and
the purchaser and returned to CYRUS or its Distributor within 8 days
of purchase. No Dealer or Distributor may vary the terms of this
warranty which is personal to the original Purchaser and is not
transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the Dealer
from whom the equipment was purchased.
This warranty excludes:
Damage caused through neglect, accident, misuse, wear and
tear, or through incorrect installation, adjustment or repair by
unauthorised personnel. Any unauthorised servicing will result in
loss of guarantee.
Liability for damage or loss occurring in transit to or from the
purchaser.
Consequential damage, loss or injury, arising from or in
conjunction with this equipment.
Equipment for attention under warranty should be consigned return
carriage paid. If returned equipment is found to comply with the
published specification, MISSION reserves the right to raise a charge.
The above conditions do not affect your statutory rights as a
consumer.

SPECIFICATIONS

Power Supply
Voltage:....................................................................As plate on rear of unit
Power Consumption
Playing ..................................................................................................12W
Standby...................................................................................................6W
Safety Requirements .................................................................... EN60065
Enclosure
Dimensions (WxHxD)..................................................... 215 x 75 x 365mm
Weight.................................................................................................3.1Kg
Material ..............................................................................Die cast chassis
Audio Performance
Output Level......................................................................................2V rms
Input Impedance ..................................................................................50
Frequency Response ............................................................. 20-20,000Hz
Channel Separation .............................................................>95dB @ 1kHz
SNR (using silent track) .................................................................. >98dBA
THD @ -10dB ..................................................................................0.008%
Cyrus reserves the right to change all specifications without notice. E &OE
User Instructions
>95dB@20kHz
G B
G B