Bluerock Tools CG-211Y Panduan Operasional - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Operasional untuk Sistem Pengelasan Bluerock Tools CG-211Y. Bluerock Tools CG-211Y 16 halaman. Pipe torch/burner machine

Halaman Cetak
C G - 2 1 1 Y
T O R C H

RUNNING THE MACHINE

Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Consider your security and stability as well as the orientation of the machine in the work area.
Consider the work surface material, condition, strength, density and rigidity. These
o
factors directly affect the tools use.
WARNING: Ensure the piece being cut will be stable after the cut has been made.
o
Ø Ensure the work surface and machine are free of debris, oil, etc.
NOTE: The machine will deviate from the cut if the material is not clean (bare) and
o
seamless.
Ø Carefully place machine at the start of the cut ensuring the wheels gently make contact with the
cutting surface. If cutting pipe, it is generally easiest to start at the top of the pipe.
Ø Adjust the main chain tightening wing-nut so that the clutch carriage assembly is in a low
position.
Ø Loop the chain through the top of the clutch sprocket and around the pipe.
Ø Interlock the chain as in the illustration below.
Take out the appropriate number of chain lengths so the chain is moderately tight.
o
A quick way to figure out the specific number of chain lengths to use can be found using
o
the following equation:
B U R N E R
M A C H I N E
§
D=d+12
D= The number of sections
•
d= The diameter of pipe.
•
8