Bluerock Tools CG-211Y 운영 매뉴얼 - 페이지 11
{카테고리_이름} Bluerock Tools CG-211Y에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bluerock Tools CG-211Y 16 페이지. Pipe torch/burner machine
페이지 인쇄C G - 2 1 1 Y
T O R C H
RUNNING THE MACHINE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Consider your security and stability as well as the orientation of the machine in the work area.
Consider the work surface material, condition, strength, density and rigidity. These
o
factors directly affect the tools use.
WARNING: Ensure the piece being cut will be stable after the cut has been made.
o
Ø Ensure the work surface and machine are free of debris, oil, etc.
NOTE: The machine will deviate from the cut if the material is not clean (bare) and
o
seamless.
Ø Carefully place machine at the start of the cut ensuring the wheels gently make contact with the
cutting surface. If cutting pipe, it is generally easiest to start at the top of the pipe.
Ø Adjust the main chain tightening wing-nut so that the clutch carriage assembly is in a low
position.
Ø Loop the chain through the top of the clutch sprocket and around the pipe.
Ø Interlock the chain as in the illustration below.
Take out the appropriate number of chain lengths so the chain is moderately tight.
o
A quick way to figure out the specific number of chain lengths to use can be found using
o
the following equation:
B U R N E R
M A C H I N E
§
D=d+12
D= The number of sections
•
d= The diameter of pipe.
•
8