Asko D5434XXL S Panduan Petunjuk Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring Asko D5434XXL S. Asko D5434XXL S 16 halaman. Classic dishwasher
Juga untuk Asko D5434XXL S: Spesifikasi (2 halaman), Panduan Petunjuk Pengoperasian (20 halaman)
Halaman Cetak
WATER SUPPLY
WARNING!
Plumbing connections must comply with applicable
sanitary, safety and plumbing codes in your area.
The machine can be connected to either a hot or cold
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
Connect to cold water...
If you use oil or electricity to heat your home.
Connect to hot water (max 160 °F, 70 °C)...
If you use district heating, solar power, or geothermal
power to heat your home. Choosing a hot water connection
cuts program times and reduces the dishwasher's
electricity consumption.
The dishwasher comes with a 6-foot PEX water supply
line that has a 3/8˝ NPT female connection.
After determining where the water supply line will enter
under the sink, drill a 1-1/2˝ (38 mm) access hole and run
the line to the approximate inlet valve location shown in
the figure below. The water line inlet valve is on the right
rear of the machine.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location, such as, beneath the sink.
It is important that the water supply line and the shut off
valve have a sufficient flow volume. At least 3 gallons (12
liters) per minute must be able to pass through the line.
The water pressure should be 4.2-140 psi.
Page 6
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water line
is connected to the dishwasher.
1. Water supply
2. Water supply valve to dishwasher (not supplied)
NOTE:
Be sure to run the PEX tubing through the hole to the sink
compartment before moving the dishwasher into position.
Customer Care Center
1-800-898-1879
www.askousa.com