Ambient Technologies RCMHL Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Kontrol Jarak Jauh Ambient Technologies RCMHL. Ambient Technologies RCMHL 7 halaman. Hi/lo remote control

Halaman Cetak

Symptom

1. LED light on

receiver blinking or

battery icon on LCD

on transmitter.

2. LCD display is

blank

3. LCD display shows

"funny" display

4. Appliance does not

come on after pressing

ON/HI on tranmitter

5. Receiver cannot

receive signal.

f i r e - p a r t s . c o m

This warranty gives you specific legal rights and you may also have other rights that vary from

state to state or province to province. Answers to any questions regarding our limited warranty may be obtained by

writing our corporate offices.

Ambient Technologies warrants each new Ambient Technologies remote control against any defects that are due to

faulty material or workmanship to the original owner, for a period of five years after the original date of purchase.

This warranty and our liability does not apply to batteries, nor does it include damage to merchandise or the remote

control resulting from accident, alteration, neglect, misuse, improper installation or any other failure to follow

Ambient Technologies installation and operating instructions.

Ambient Technologies agrees to repair or replace at its option any Ambient Technologies remote control under

warranty provided it is returned postage prepaid to our warranty facility in a padded carton within the warranty

period, with proof of the original date of purchase and a brief description of the malfunction. This limited warranty

does not include the cost of removal or re-installation.

50D0033 Rev 1 June 2002

TROUBLESHOOTING

Causes

1. Low Battery

1. Wiring / Electrical Connections

2. Transmitter measures temperature exceeding

99 degrees Fahrenheit and shows "HI" on LCD

3. Distance between the transmitter and receiver

is more than 30 feet

1. Receiver is installed in an enclosure

WARRANTY

Ambient Technologies

149 Cleveland Drive

Paris KY 40361

FOR TECHNICAL SUPPORT

CALL 800-398-6195

Page 7 of 7

Action

1. Replace batteries. Change

batteries every 6 months.

2. Check battery installation and

replace batteries.

3. Press Reset button at the back of

the transmitter. The reset button is

located at the lower left corner

behind the battery cover.

1. Check wiring connections.

1. Move transmitter to a cooler

place and wait until temperature

drops below 99 degree.

1. Make sure the operating distance

is less than 30 feet

1. Make sure the receiver is not

located inside an enclosure.

Ambient Technologies

Monessen Hearth Systems

A Division Of