Ambient Technologies RCMHL Manual de instruções de instalação e funcionamento - Página 7
Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Controlo remoto Ambient Technologies RCMHL. Ambient Technologies RCMHL 7 páginas. Hi/lo remote control
Imprimir páginaSymptom
1. LED light on
receiver blinking or
battery icon on LCD
on transmitter.
2. LCD display is
blank
3. LCD display shows
"funny" display
4. Appliance does not
come on after pressing
ON/HI on tranmitter
5. Receiver cannot
receive signal.
f i r e - p a r t s . c o m
This warranty gives you specific legal rights and you may also have other rights that vary from
state to state or province to province. Answers to any questions regarding our limited warranty may be obtained by
writing our corporate offices.
Ambient Technologies warrants each new Ambient Technologies remote control against any defects that are due to
faulty material or workmanship to the original owner, for a period of five years after the original date of purchase.
This warranty and our liability does not apply to batteries, nor does it include damage to merchandise or the remote
control resulting from accident, alteration, neglect, misuse, improper installation or any other failure to follow
Ambient Technologies installation and operating instructions.
Ambient Technologies agrees to repair or replace at its option any Ambient Technologies remote control under
warranty provided it is returned postage prepaid to our warranty facility in a padded carton within the warranty
period, with proof of the original date of purchase and a brief description of the malfunction. This limited warranty
does not include the cost of removal or re-installation.
50D0033 Rev 1 June 2002
TROUBLESHOOTING
Causes
1. Low Battery
1. Wiring / Electrical Connections
2. Transmitter measures temperature exceeding
99 degrees Fahrenheit and shows "HI" on LCD
3. Distance between the transmitter and receiver
is more than 30 feet
1. Receiver is installed in an enclosure
WARRANTY
Ambient Technologies
149 Cleveland Drive
Paris KY 40361
FOR TECHNICAL SUPPORT
CALL 800-398-6195
Page 7 of 7
Action
1. Replace batteries. Change
batteries every 6 months.
2. Check battery installation and
replace batteries.
3. Press Reset button at the back of
the transmitter. The reset button is
located at the lower left corner
behind the battery cover.
1. Check wiring connections.
1. Move transmitter to a cooler
place and wait until temperature
drops below 99 degree.
1. Make sure the operating distance
is less than 30 feet
1. Make sure the receiver is not
located inside an enclosure.
Ambient Technologies
Monessen Hearth Systems
A Division Of