Ambient Weather WS-26 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Ambient Weather WS-26. Ambient Weather WS-26 8 halaman. Indoor thermo-hygrometer with daily min/max display

Halaman Cetak

2. Hour. Press the [+] or [-] key to increase or decrease the hour. Press the SET key to

advance to the next setting.

3. Minute. Press the [+] or [-] key to increase or decrease the minute. Press the SET key to

advance to the next setting.

4. Month-Day/Day-Month format. Press the [+] key to switch between mm-dd and dd-mm

date format. Press the SET key to advance to the next setting.

5. Month. Press the [+] or [-] key to increase or decrease the month. Press the SET key to

advance to the next setting.

6. Day. Press the [+] or [-] key to increase or decrease the day. Press the SET key to advance

to the next setting.

7. Year. Press the [+] or [-] key to increase or decrease the year. Press the SET key to advance

to the next setting.

8. Alarm Hour. Press the [+] or [-] key to increase or decrease the alarm hour. Press the SET

key to advance to the next setting.

9. Alarm Minute. Press the [+] or [-] key to increase or decrease the alarm minute. Press the

SET key to advance to the next setting.

10. Temperature Units of Measure. Press the [+] or [-] key to switch between °F and °C units of

measure. Press the SET key to advance to the next setting.

11. Max/Min Clearing. The Max/Min can be programmed to clear daily (at midnight) or

manually. Press the [+] or [-] key to switch between "Clears Daily" and Clears Manually.

Press the SET key to exit setting.

5.2 Day Month/Year/Alarm Display

Press the SET key (do not hold) to toggle between the Day/Month, Year and Alarm Time.

5.3 Time Alarm

To turn on and off the Time Alarm, press the CLEAR/- button and the alarm icon will appear

when set, and disappear when disabled.

5.4 Reset Max/Min

To reset the Max/Min values, press and hold the CLEAR/- button for 3 seconds.

5.5 Adjustment or Calibration

Note: The calibrated value can only be adjusted on the console.

Note: The measured humidity range is between 10 and 99%. Humidity cannot be accurately

measured outside of this range. Thus, the humidity cannot be calibrated below 10% or above 99%.

The purpose of calibration is to fine tune or correct for any sensor error associated with the devices

margin of error. The measurement can be adjusted from the console to calibrate to a known source.

Calibration is only useful if you have a known calibrated source you can compare it against, and is

optional. This section discusses practices, procedures and sources for sensor calibration to reduce

manufacturing and degradation errors. Do not compare your readings obtained from sources such as

the internet, radio, television or newspapers. They are in a different location and typically update once

per hour.

The purpose of your weather station is to measure conditions of your surroundings, which vary

significantly from location to location.

Version 1.1

Page 4