AMC SRL400/R Manuale dell'installatore - Pagina 4
Sfoglia online o scarica il pdf Manuale dell'installatore per Sensori di sicurezza AMC SRL400/R. AMC SRL400/R 6. Two-way radio buzzer kit for r400 series control units
Stampa la paginaDESCRIPTION OF THE ELECTRONIC BOARD OF THE TRANSMITTER
Learn key
fastening holes
The CSR400 transmitter has been designed to be used with radio-controlled R 400 series control units; as such, it does not require
to be programmed. Connect the FLAT cable of the transmitter board to the multi-polar socket in the control unit and follow the
programming steps described in the next chapters.
LOGIC OF THE LED ON THE TRANSMITTER
TWO-COLORED EXTERNAL LED:
GREEN COMBINATION = OPERATION OK
ORANGE COMBINATION = FAILURE
RED COMBINATION = FAULT
Two-colored LED - green combination:
- Brief green flash every 4 seconds: in standby operating mode
- Steady on green: system enabled
- Slowly flashing green: system alarm
Two-colored LED - orange combination:
- flashes orange every 4'': battet not charged
- Slow orange flash: battery charginb (low battery)
- Steady on orange: battery almost fully recharged
Two-colored LED - red combination:
- Slow red flash: very low battery (no power)
- Fast red flash: battery dead, replace
- Steady on red: buzzer has lost supervision.
GREEN LED inside the transmitter (RADIO PART SYSTEM AND CHECK):
- Steady on: transmitter not associated (not programmed for a buzzer)
- Steady on for 1 second: control transmitted to buzzer. (ALL OK)
- Fast flah for 1 second: status signal reception from buzzer (ALL OK)
- Slowly flashing: during self-learning phase (see below)
www.amcelettronica.com
Connector
threaded antenna
green LED
Two-colored LED
SRL400/R V1.0 EN