- ページ 4

セキュリティセンサー AMC SRL400/RのPDF インストーラー・マニュアルをオンラインで閲覧またはダウンロードできます。AMC SRL400/R 6 ページ。 Two-way radio buzzer kit for r400 series control units

DESCRIPTION OF THE ELECTRONIC BOARD OF THE TRANSMITTER

Learn key

fastening holes

The CSR400 transmitter has been designed to be used with radio-controlled R 400 series control units; as such, it does not require

to be programmed. Connect the FLAT cable of the transmitter board to the multi-polar socket in the control unit and follow the

programming steps described in the next chapters.

LOGIC OF THE LED ON THE TRANSMITTER

TWO-COLORED EXTERNAL LED:

GREEN COMBINATION = OPERATION OK

ORANGE COMBINATION = FAILURE

RED COMBINATION = FAULT

Two-colored LED - green combination:

- Brief green flash every 4 seconds: in standby operating mode

- Steady on green: system enabled

- Slowly flashing green: system alarm

Two-colored LED - orange combination:

- flashes orange every 4'': battet not charged

- Slow orange flash: battery charginb (low battery)

- Steady on orange: battery almost fully recharged

Two-colored LED - red combination:

- Slow red flash: very low battery (no power)

- Fast red flash: battery dead, replace

- Steady on red: buzzer has lost supervision.

GREEN LED inside the transmitter (RADIO PART SYSTEM AND CHECK):

- Steady on: transmitter not associated (not programmed for a buzzer)

- Steady on for 1 second: control transmitted to buzzer. (ALL OK)

- Fast flah for 1 second: status signal reception from buzzer (ALL OK)

- Slowly flashing: during self-learning phase (see below)

www.amcelettronica.com

Connector

threaded antenna

green LED

Two-colored LED

SRL400/R V1.0 EN