Amdi Smart/Chat Foglio di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Foglio di istruzioni per Telefono cellulare Amdi Smart/Chat. Amdi Smart/Chat 3. Augmentative communication devices with levels

Stampa la pagina
RECORD OPERATION:
Note: It is important that the built-in microphone located on the front right-hand side of the Smart/Chat is
open and clear during recording.
Recording procedure:
1.
Before recording any messages onto a new level, it is recommended that you do a master erase.
2.
Slide in the desired overlay with the hole punched for the desired level the voices will be recorded on.
See diagram for Hole Pattern for Level Selection.
3.
Set the RECORDING switch to the ON (see diagram below for RECORDING switch location).
4.
Turn the Smart/Speak ON. Lift the panel door on the back of the Smart/Chat. Slide the VOLUME
control wheel to the left, until it clicks ON.
5.
The recording LED on the top right-hand side of the grid will turn RED. When the recording LED
flashes in about 10 seconds, slide the RECORDING switch to the OFF position. The master erase is
complete for that level and only that level. All other levels will not be erased. You can now begin
recording your messages.
6.
Set the VOLUME control, by sliding the wheel to the left until it reaches the desired volume level.
7.
Press and hold in the Recording Button. The Recording Button must be engaged for the entire
recording process. An external recording switch can be used by plugging a switch into the jack on the
back of the Smart/Chat labeled EXT REC. The RECORDING switch can also be used.
8.
Select one of the 16 message squares on the face of the Smart/Chat and depress that message square
momentarily, when the recording LED on the top right-hand side on the grid starts to flash begin to say
your message into the built in microphone located on the front right hand side of the Smart/Chat.
9.
When you are finished saying the message, release the Recording Button or the external recording
switch or slide the RECORDING switch to the OFF position.
10. Each of the remaining buttons can be programmed in the same manner for that level.
Master Erase procedure:
The Master Erase will only erase the messages for the level that is selected when performing this function.
1.
Turn the Smart/Chat off by sliding the volume control wheel to the right until you hear it click.
2.
Slide in the desired overlay with the hole punched for the desired level you want to erase. See diagram
for Hole Pattern for Level Selection.
3.
Set the RECORDING switch to the ON position (see diagram for RECORDING switch location).
4.
The Recording switch must be ON for the entire master erase process.
5.
Turn the Smart/Chat ON. Lift the panel door on the back of the Smart/Chat. Slide the VOLUME
control wheel to the left, until it clicks ON.
6.
The recording LED on the top right-hand side of the grid will turn RED. When the recording LED
flashes in about 10 seconds, slide the recording switch to the OFF position. The master erase is
complete for that level and only that level. All other levels will not be erased.
Hole Pattern for Level Selection:
Templates are available on our website
Level 1
●
1
○
2
○
3
Level 1 – punch hole 1 only
Level 2 – punch hole 2 only
Level 3 – punch hole 3 only
www.amdi.net
Level 2
Level 3
○
○
●
○
○
●
for Overlay/Designer and Mayer-Johnson Boardmaker.
Level 4
●
○
●
Level 4 – punch hole 3 and 1
Level 5 – punch holes 3 and 2
Level 6 – punch holes 3 and 2 and 1
Level 5
Level 6
○
●
●
●
●
●