Amdi Smart/Chat Foglio di istruzioni - Pagina 3

Sfoglia online o scarica il pdf Foglio di istruzioni per Telefono cellulare Amdi Smart/Chat. Amdi Smart/Chat 3. Augmentative communication devices with levels

Stampa la pagina
PLAYBACK OPERATION:
*If you are using the optional external speaker, be sure to plug the external speaker in to the jack in the back of the
Smart/Chat labeled EXT SPK and then perform steps 1 through 4
1.
Turn the Smart/Speak ON. Lift the panel door on the back of the Smart/Chat. Slide the VOLUME
control wheel to the left, until it clicks ON.
2.
Set the VOLUME control, by sliding the wheel to the left until it reaches the desired volume level.
3.
Slide in the desired overlay with the hole punched for the desired level the groups were recorded on.
See diagram for Hole Pattern for Level Selection.
4.
Select one of the 16 message squares on the face of the Smart/Chat and depress that message square
for message playback.
OVERLAY DESIGN AND LAYOUT:
Graphic overlays (picture cards) can be changed easily by simply sliding the overlay through the side slot of the
housing grid. There are several methods you can use to make overlays for the Smart/Chat. Options include:
1.
Drawing or printing corresponding icons or words on a sheet of 6" x 13 ¼" paper. Section each icon
so that it appears in each of the 16 message switch cutouts.
2.
Developing your custom overlay using the Overlay Designer and Tech/Syms Software. Blank
templates are available on the INSTRUCTION CD and on our website @ www.amdi.net.
3.
Developing your custom overlay using the Mayer-Johnson Boardmaker software. Blank templates are
available on the INSTRUCTION CD and on our website @ www.amdi.net.
CLEANING THE SMART/TALK
Note: DO NOT SUBMURGE THE SMART/SPEAK IN WATER OR ALLOW WATER TO ENTER THE
EXTERNAL SPEAKER, RECORD JACK OR SPEAKER HOLES... THE SMART/SPEAK IS WATER
RESISTANT – NOT WATER PROOF.
1.
Turn the Smart/Chat off.
2.
Remove the overlay from the grid.
3.
With a wet wash cloth and mild soap wipe the soiled areas clean.
4.
To rinse, use a wet sponge (cold water) and wipe the away the soapy area.
5.
The grid can easily be removed for cleaning by unscrewing the 6 Phillips head screws on the back of
the Smart/Chat.
Care and Maintenance
The Smart/Chat is designed to automatically power down after a message is played. However, the power down
mode is still an active mode and will drain some power from the battery, affecting battery life. Therefore, if the
Smart/Chat is not going to be used for a long period of time (2 to 3 hours) it is recommended that the unit be turned
off.
If the Smart/Chat should fail to operate, or operates incorrectly, follow these steps:
1.
Check that the batteries are fully charged.
2.
Check that the Smart/Chat is ON and a Message has been recorded at that level.
3.
Make sure that there are no obstacles blocking the message membrane square.
4.
Turn the Smart/Chat OFF for 15 Seconds, then back ON and retry playback.
5.
For further assistance, feel free to contact our technical support team at 1-888-353-AMDI (2634).
200 F
R
, H
RANK
OAD
ICKSVILLE
P
: (516) 822-0808 F
: (516) 822-6611
HONE
AX
1-888-353-AMDI
://
.
HTTP
WWW
AMDI
, NY 11801
.
NET