D3FY SPORTS Conqu3st Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Attrezzatura per paintball D3FY SPORTS Conqu3st. D3FY SPORTS Conqu3st 14.
Stampa la paginathe O-ring is missing from the valve, the paintball marker will
leak from the ASA as soon as an air tank is secured to the
marker.
GETTING STARTED
1.Make sure the Safety Button (I-50) is on the "SAFE" position.
Push the safety button from the "PUSH SAFE" side of the
trigger frame.
2.Attach a barrel blocking device (X-01) on the tip of the barrel.
3.Install a Co2/HPA air tank. Firmly screw the air tank clockwise
into the markers ASA (X-46).
and has a urethane o-ring on the valve to prevent an air leak.
Caution:
Never use any hand tools to screw the air tank on
or off from the ASA.
4.Install a paintball loader to the feedneck (X-16) and tighten
the Clamping Screw (S-18) with a 3mm Allen key.
5.Fill up the loader with .68 caliber paintballs.
6.Put on your paintball goggles and cock back the Bolt Cocking
Pin (I-20).
7.Remove the barrel blocking device from the tip of the barrel.
8.Point the marker in a "SAFE" direction before unlocking the
safety button. Unlock the safety by pushing the safety button
from the opposite side of "PUSH SAFE" on the trigger frame.
Caution: The CONQU3ST is now live and ready to fire.
Tip:
Make sure the tank is full
9.Ready to Fire. Important: Only use the marker in a safe and/
or designated playing field.
10.Check the velocity/fps (feet per second) using a
chronograph designed for the sport of paintball. If adjustment
is needed, adjust the velocity by turning the Velocity/Spring
Guide (I-31) adjustment screw with a 3mm Allen key. To
increase the velocity, turn the screw in (clockwise). To
decrease the velocity, turn the screw out (counter-clockwise).
Note:
After each adjustment, take a few shots for the spring
to set. Never adjust the marker to shoot above 300fps or the
field rules/local laws permit.
11.After playing, remove all paintballs from your hopper/loader.
Then detach the hopper/loader from the paintball marker.
Caution:
There may be 1-2 paintballs in the breach of the
paintball marker. In a safe direction, take a couple of shots to
insure the marker is completely clear of any paintballs.
12.Attach the barrel blocking device on the tip of the barrel.
13.Remove the Co2/HPA air tank. Firmly unscrew the tank
counter-clockwise until it comes out of the ASA.
removing the air tank, excess air will release from the ASA.
Caution:
Never expose any skin to the ASA relief hole when
removing the air tank. Never store the paintball marker with
an air tank attached to the ASA.
14.Un-cock the marker by pulling the trigger once.
sure to have the bolt of the marker in the un-cocked position
when not in use.
15.Push the safety button to the "SAFE" position.
Tip:
When
Note:
GETTING STARTED
Make
7