D3FY SPORTS Conqu3st Kullanıcı El Kitabı - Sayfa 7

Paintball ekipmanları D3FY SPORTS Conqu3st için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. D3FY SPORTS Conqu3st 14 sayfaları.

Sayfayı Yazdır

the O-ring is missing from the valve, the paintball marker will

leak from the ASA as soon as an air tank is secured to the

marker.

GETTING STARTED

1.Make sure the Safety Button (I-50) is on the "SAFE" position.

Push the safety button from the "PUSH SAFE" side of the

trigger frame.

2.Attach a barrel blocking device (X-01) on the tip of the barrel.

3.Install a Co2/HPA air tank. Firmly screw the air tank clockwise

into the markers ASA (X-46).

and has a urethane o-ring on the valve to prevent an air leak.

Caution:

Never use any hand tools to screw the air tank on

or off from the ASA.

4.Install a paintball loader to the feedneck (X-16) and tighten

the Clamping Screw (S-18) with a 3mm Allen key.

5.Fill up the loader with .68 caliber paintballs.

6.Put on your paintball goggles and cock back the Bolt Cocking

Pin (I-20).

7.Remove the barrel blocking device from the tip of the barrel.

8.Point the marker in a "SAFE" direction before unlocking the

safety button. Unlock the safety by pushing the safety button

from the opposite side of "PUSH SAFE" on the trigger frame.

Caution: The CONQU3ST is now live and ready to fire.

Tip:

Make sure the tank is full

9.Ready to Fire. Important: Only use the marker in a safe and/

or designated playing field.

10.Check the velocity/fps (feet per second) using a

chronograph designed for the sport of paintball. If adjustment

is needed, adjust the velocity by turning the Velocity/Spring

Guide (I-31) adjustment screw with a 3mm Allen key. To

increase the velocity, turn the screw in (clockwise). To

decrease the velocity, turn the screw out (counter-clockwise).

Note:

After each adjustment, take a few shots for the spring

to set. Never adjust the marker to shoot above 300fps or the

field rules/local laws permit.

11.After playing, remove all paintballs from your hopper/loader.

Then detach the hopper/loader from the paintball marker.

Caution:

There may be 1-2 paintballs in the breach of the

paintball marker. In a safe direction, take a couple of shots to

insure the marker is completely clear of any paintballs.

12.Attach the barrel blocking device on the tip of the barrel.

13.Remove the Co2/HPA air tank. Firmly unscrew the tank

counter-clockwise until it comes out of the ASA.

removing the air tank, excess air will release from the ASA.

Caution:

Never expose any skin to the ASA relief hole when

removing the air tank. Never store the paintball marker with

an air tank attached to the ASA.

14.Un-cock the marker by pulling the trigger once.

sure to have the bolt of the marker in the un-cocked position

when not in use.

15.Push the safety button to the "SAFE" position.

Tip:

When

Note:

GETTING STARTED

Make