Da-Lite Multi Format Imager Libro di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Libro di istruzioni per Accessori per proiettori Da-Lite Multi Format Imager. Da-Lite Multi Format Imager 12.
Anche per Da-Lite Multi Format Imager: Libro di istruzioni (20 pagine)

Stampa la pagina

Post Installation Procedures

Test installation by carefully running mask surface up and

down 2-3 times. Be prepared to stop screen. Standard Duty

Cycle: 1 MIN. ON I 3 MIN. OFF.

CAUTION! Excessive countinous operation may cause

overheating. If motor overheats put switch in center-off

position and allow motor to cool for 30 minutes.

ATTENTION! Le fonctionnement continu et excessif peut

provoquer une surchauffe. Si le moteur surchauffe, mettez

le commutateur au centre sur la position Off et laissez le

moteur refroidir pendant 30 minutes.

Travel Adjustments:

Masking travel is stopped automatically in the up and down

positions by limit switches that are properly adjusted at the

factory. Should it be necessary to adjust the stop positions,

proceed in the following manner:

NOTE: Use a screw driver or 5/32" Allen wrench to make

adjustments.

MORE SCREEN DROP

1 . Place operating switch in "down" position.

2. When the mask stops, turn the "down" limit knob (WHITE) one

turn counterclockwise. Test by raising the mask

approximately two feet, then lower again. Repeat until desired

picture surface position is attained.

LESS SCREEN DROP

Raise picture surface approximately two feet above

desired level.

2. Place operating switch in "off" position.

3. Turn the "down" limit knob (WHITE) one turn clockwise. Test

by raising the mask approximately two feet, then lower again.

Repeat until desired picture surface position in attained.