Da-Lite Multi Format Imager 지침서 - 페이지 9

{카테고리_이름} Da-Lite Multi Format Imager에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Multi Format Imager 12 페이지.
Da-Lite Multi Format Imager에 대해서도 마찬가지입니다: 지침서 (20 페이지)

페이지 인쇄

Post Installation Procedures

Test installation by carefully running mask surface up and

down 2-3 times. Be prepared to stop screen. Standard Duty

Cycle: 1 MIN. ON I 3 MIN. OFF.

CAUTION! Excessive countinous operation may cause

overheating. If motor overheats put switch in center-off

position and allow motor to cool for 30 minutes.

ATTENTION! Le fonctionnement continu et excessif peut

provoquer une surchauffe. Si le moteur surchauffe, mettez

le commutateur au centre sur la position Off et laissez le

moteur refroidir pendant 30 minutes.

Travel Adjustments:

Masking travel is stopped automatically in the up and down

positions by limit switches that are properly adjusted at the

factory. Should it be necessary to adjust the stop positions,

proceed in the following manner:

NOTE: Use a screw driver or 5/32" Allen wrench to make

adjustments.

MORE SCREEN DROP

1 . Place operating switch in "down" position.

2. When the mask stops, turn the "down" limit knob (WHITE) one

turn counterclockwise. Test by raising the mask

approximately two feet, then lower again. Repeat until desired

picture surface position is attained.

LESS SCREEN DROP

Raise picture surface approximately two feet above

desired level.

2. Place operating switch in "off" position.

3. Turn the "down" limit knob (WHITE) one turn clockwise. Test

by raising the mask approximately two feet, then lower again.

Repeat until desired picture surface position in attained.