AMERITRON AL-82 Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Amplificatore AMERITRON AL-82. AMERITRON AL-82 16. Full power
Anche per AMERITRON AL-82: Manuale di istruzioni (16 pagine)

TRANSFORMER INSTALLATION

For 220V connections(see Fig. 3), follow the first three
steps on the 240V operation on page 4, then follow the
steps below:
1. Slide the RED boot back on the BRN/WHT
wire
2. Clip the terminal connector off the wire and
slide the RED boot off.
3. Remove the restraint from the GRN wire and
slide the RED boot on to the wire.
4. Solder the terminal connector to the GRN wire.
5. Tape up the BRN/WHT wire because it will not
be used.
Install the tubes, chimneys, anode. bracket and plate cap
connectors as follows: (see Fig. 4)
1. After removing the packing material from
around the anode connectors, install the 3-
500z tubes. NOTE: One of the tube pins is
offset. This offset pin "keys" the tube base
and socket. Install the tube by aligning the
tube pins with the socket contact terminals,
then seat the tube with vertical pressure ON-
LY. Do not "rock" or "twist" the tube.
TUBE INSTALLATON
Fig. 4 Top View of 3-500z tubes
Fig.
2. Place the chimneys over the tubes and seat with
the metal clips inside each chimney. Do not
apply excessive force or the glass chimney
may crack.
3. Attach the blocking capacitors to the anode
bracket and secure with the two 6/32 screws.
4. install the plate cap connectors on the tubes in
the positions shown. Be careful not to drop
any hardware inside the chassis.