AMERITRON ALS-500RC Istruzioni per l'uso - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'uso per Unità di controllo AMERITRON ALS-500RC. AMERITRON ALS-500RC 4.

PORT B

Port B allows operation of the Frequency Select Switch and the PWR LED.

CONNECTIONS

1. Place the ALS-500RC in a convent location at your operating station.

2. Plug one of the supply patch cords into port A of the remote head and note

which color was used. Route the other end of the same cable to the

amplifier and plug into Remote A.

Switch is off.

3. Connect the other supply patch cable into port B. Route the other end to the

amplifier and plug into Remote B. Make sure the amplifier's Frequency

Select Switch is in the Remote position.

4. The ALS-500RC's Relay Jack operates the same as the amplifier's Relay

Jack. Use the ALS-500RC's relay jack (RLY) or the Amplifier's Relay

Jack, whichever makes installation easier.

Instruction Manual for operation of the relay jack.

OPERATION

The controls on the ALS-500RC serve the same function as the controls on front

of the Amplifier. The Amplifier's Power switch must be in the off position and

the Frequency Select Switch in the Remote position.

Set the ALS-500RC's Frequency switch to the same frequency as the

transceiver.

When the ALS-500RC switch is turned on the meter and power light should

illuminate.

When the transceiver is placed into transmit the TX light should illuminate and

current meter should deflect.

The O/L light will illuminate when the amplifier reaches a VSWR that is too

high or the frequency switch is in the wrong position. Placing the power switch

off and back on will reset the O/L light.

Make sure the amplifier's Power

Refer to the Amplifier's