Akva SUBSEA FEEDER Manuale d'uso - Pagina 13

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzatura da pesca Akva SUBSEA FEEDER. Akva SUBSEA FEEDER 20.

4.3 ATTACHING TO PEN

Attach the AKVA Subsea Feeder to the edge of the cage using four loading straps attached

to rope, as shown in illustration 6:

weather

direction.

The ropes must be attached to the pen as instructed in the relevant user manuals for the specific

pen and net used. In some pen, ropes may be attached to the handrail. Whether this is possible

depends on the capacity of the specific pen and handrail. In cases where the rope must be

attached to the bottom of the post or around the pen ring, pull it through the net as instructed

in the user manual for the relevant net. Reinforcing the relevant section of the net will probably

be required.

When installing the AKVA Subsea Feeder in a Tubenet™, follow the installation procedure

described in this user manual. Personnel who will be installing the Tubenet™ shall review and

familiarise themselves with the process before proceeding with the installation. When installing

the Subsea Feeder in a Tubenet™, do this before the inner float in the Tubenet™ is moored into

position in the middle of the outer float. Temporarily moore the inner float near the edge of the

floating collar to simplify lifting the Subsea Feeder into position in the tube. Make sure to use

approved lifting equipment and a crane with sufficient capacity for the operation. We recommend

using two cranes when lifting the AKVA Subsea Feeder for installation in a Tubenet™.

Mooring the AKVA Subsea Feeder 45 degrees against the

DOCUMENT NO:

DOCUMENT PART:

DC10000901

10001800

REVISION NO: