Canon PIXMA MX340 Series Manuale di servizio semplificato - Pagina 8

Sfoglia online o scarica il pdf Manuale di servizio semplificato per Stampante All in One Canon PIXMA MX340 Series. Canon PIXMA MX340 Series 35. Cartridge reset
Anche per Canon PIXMA MX340 Series: Manuale di installazione (17 pagine), Manuale di installazione (11 pagine), Manuale di configurazione della rete (26 pagine), Opuscolo (2 pagine), Manuale (8 pagine), Manuale (10 pagine), Risoluzione dei problemi di configurazione della rete (13 pagine), Manuale di installazione della rete (16 pagine), Manuale di connessione (11 pagine), Manuale (4 pagine)

Stampa la pagina
Canon PIXMA MX340 Series Manuale di servizio semplificato

1-3. FAX Errors

For errors other than those listed below, please refer to the "G3 / G4 Facsimile Error Code List (Rev.
2)" (HY8-23A0-020 in English).
< User error codes >
Error
TX /
code
RX
#001
TX
Document jam
#003
TX /
Document is too long, or page time-over
RX
#005
TX /
Initial identification (T0 / T1) time-over
RX
#012
TX
No recording paper at the receiving machine
#017
TX
Redial time-over, but no DT detected
#018
TX
Auto dialing transmission error, or redial time-over
#022
TX
Call failed (no dial registration)
#037
RX
Memory overflow at reception of an image
#046
RX
Direct mail rejection (rejection of mail reception)
#059
TX
Dialed number not matches the CSI of the
connected machine
#085
TX
No color fax function supported in the receiving
machine
#099
TX /
Transmission terminated mid-way by pressing the
RX
Stop button
#995
TX /
During TX (sending):
RX
Memory transmission reservation cancelled
During RX (receiving):
Image data received in the memory cleared
< Service error codes >
Error
TX /
code
RX
##100 TX
Re-transmission of the procedure signal has been
attempted the specified number of times, but failed.
##101 TX /
Sender's modem speed does not match the
RX
receiving machine.
##102 TX
Fallback is not available.
##103 RX
EOL has not been detected for 5 seconds (or 15
seconds in CBT).
##104 TX
RTN or PIN has been received.
##106 RX
The procedure signal has been expected for 6
seconds, but not received.
##107 RX
Fallback is not available at the sending machine.
Meaning
Meaning
(7/37)
Solution
(parts that are likely to be faulty)
- Document upper guide
- Document upper guide
- Check the telephone line type settings
(rotary pulse / touch tone).
- Check the telephone line type settings
(rotary pulse / touch tone).
- Register a dial number.
- Delete unnecessary image data from
the memory.
- Register the dial number of the calling
machine.
- Register the dial number (CSI)
properly on the receiving machine.
- Send a fax in the B&W mode.
Solution
(parts that are likely to be faulty)
- Try a higher transmission level.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.
- Increase the transmission level of the
sending machine.