Canon PIXMA MX410 Series Risoluzione dei problemi di configurazione della rete - Pagina 10

Sfoglia online o scarica il pdf Risoluzione dei problemi di configurazione della rete per Stampante All in One Canon PIXMA MX410 Series. Canon PIXMA MX410 Series 46. Cartridge reset
Anche per Canon PIXMA MX410 Series: Manuale di installazione della rete (23 pagine), Specifiche tecniche (2 pagine), Manuale delle funzioni (30 pagine), Manuale delle funzioni (21 pagine), Manuale delle funzioni (15 pagine), Manuale di configurazione della rete (24 pagine), Manuale di configurazione della rete (20 pagine), Menu manuale (34 pagine), Manuale (14 pagine), Manuale (4 pagine)

Stampa la pagina
Canon PIXMA MX410 Series Risoluzione dei problemi di configurazione della rete
6-A
WEP
G
I
1
Enter the network key in WEP Key (F).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
2
Select Key Length (G).
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
•
bit.
3
Select Key Format (H).
Select ASCII when the network key is 5 or 13 characters.
•
Select Hex when it is 10 or 26 characters (digits).
4
Select Key ID (I).
When using AirPort, select 1 in the screen.
•
Selecting other key numbers will disable the connection between the machine and
AirPort.
5
Select Authentication (J), then click OK (K).
Go to .
WPA/WPA2
Disable
F
H
J
K
6-B
WPA/WPA2
L
1
Enter the network key in Passphrase (L).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
2
Select Dynamic Encryption Type (M), then click OK (N).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
•
When the access point is set to operate in IEEE802.11n, TKIP cannot be used.
Change the encryption type to something other than TKIP or change the standard to
something other than IEEE802.11n, then configure wireless LAN settings again.
•
When the access point is set to operate in IEEE802.11n and IEEE802.11g with TKIP
set as an encryption standard, communication is established using IEEE802.11g.
Go to .
7
The Manual Setup screen returns. Click Connect.
•
After that, follow the on-screen instructions to proceed with settings.
Disable
M
N