Cognex DataMan 8600 Series Manuale di riferimento - Pagina 8
Sfoglia online o scarica il pdf Manuale di riferimento per Lettore di codici a barre Cognex DataMan 8600 Series. Cognex DataMan 8600 Series 14. Handheld verifier
Anche per Cognex DataMan 8600 Series: Manuale di riferimento rapido (8 pagine)
Stampa la pagina
2. The stand-off snap-fits into the reader.
Calibration
1. Start the DataMan Setup Tool and connect to your reader.
2. Select the Code Quality Settings task pane.
3. Check the box for Verification Enabled under the Verification tab.
4. Place the verifier against the calibration card with the symbol centered below the reader, and squeeze the trigger.
5. Continue squeezing the trigger. Calibration can take several seconds.
The DataMan Setup Tool displays a graphic guide if the symbol is not precisely aligned with the reader. Adjust
the position and rotation of the reader until the center of the
there is no more than 10 degrees rotation between the symbol and the reader. The reader beeps once when
calibration is complete.
6. The system displays a green check box that says System Calibrated under Calibration in Verification Settings.
red
rectangle lies inside the
8
Getting Started
green
rectangle and