- ページ 8

バーコードリーダー Cognex DataMan 8600 SeriesのPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Cognex DataMan 8600 Series 14 ページ。 Handheld verifier
Cognex DataMan 8600 Series にも：クイック・リファレンス・マニュアル (8 ページ)

ページを印刷する

2. The stand-off snap-fits into the reader.

Calibration

1. Start the DataMan Setup Tool and connect to your reader.

2. Select the Code Quality Settings task pane.

3. Check the box for Verification Enabled under the Verification tab.

4. Place the verifier against the calibration card with the symbol centered below the reader, and squeeze the trigger.

5. Continue squeezing the trigger. Calibration can take several seconds.

The DataMan Setup Tool displays a graphic guide if the symbol is not precisely aligned with the reader. Adjust

the position and rotation of the reader until the center of the

there is no more than 10 degrees rotation between the symbol and the reader. The reader beeps once when

calibration is complete.

6. The system displays a green check box that says System Calibrated under Calibration in Verification Settings.

red

rectangle lies inside the

Getting Started

green

rectangle and