Astro Pneumatic Tool 4008 Manuale di avvio rapido - Pagina 3
Sfoglia online o scarica il pdf Manuale di avvio rapido per Spruzzatore di vernice Astro Pneumatic Tool 4008. Astro Pneumatic Tool 4008 4.
Stampa la paginaMODEL:
4. Painting with the sprayer
• Begin spraying. Always keep the spray gun at a right angle
to the work surface.
• Keep the nozzle about 6 to 9 inches from the work surface
throughout the stroke and always keep the gun in motion while
spraying. Stopping gun movement in mid-stroke will cause a
build up of paint and result in runs. Do not fan the gun from side
to side while painting. This will cause a build-up of paint in the
center of the stroke and an insufficient coating at each end.
• Trigger the gun properly. Start the gun moving at the beginning
of the stroke BEFORE SQUEEZING THE TRIGGER. Release
the trigger BEFORE STOPPING GUN MOVEMENT at the end
of the stroke. This procedure will feather (blend) each stroke
with the next without showing overlap or unevenness.
• The amount of paint being applied can be varied by the speed
of the stroke, distance from the surface and adjustment of the
fluid control knob.
• Use a piece of cardboard as a shield to catch overspray at the
edges of the work to protect other surfaces. Use masking tape
to cover other areas if needed.
4008
PRODUCT TYPE:
SPRAY GUN WITH CUP
RED HANDLE 1.8MM NOZZLE
INSTALLATION
1. Cleaning the air hose
• A 1/4" air hose is required, with a maximum length of 25 ft.
• Clean the air hose of accumulated dust and moisture
before connecting it to the air supply.
Note: If a longer air hose is required, connect a 3/8" air
hose to the 1/4" air hose to ensure the spray gun has the
necessary air supply.
2. Connecting to the air supply
• Always use clean dry air. Excessive moisture and dirt will
greatly reduce the life of any air motor. We recommend the
installation of an in-line filter-regulator as close to the
tool as possible.
• Ensure all hoses and fittings are the correct size and
secured tightly.
WARNING: Lubricators should not be used with spray
guns. The use of an inline lubricator will damage
the paint finish.
Recommended Air Line Set-Up
Part
Description
A
Spray Gun
B
Regulator
C
Quick Plug
D
Quick Coupler
E
Air Hose
F
In-line Filter
G
Air Compressor
Page 3