Astro Pneumatic Tool 4008 Hızlı Başlangıç Kılavuzu - Sayfa 3

Boya Püskürtücü Astro Pneumatic Tool 4008 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Astro Pneumatic Tool 4008 4 sayfaları.

Sayfayı Yazdır

MODEL:

4. Painting with the sprayer

• Begin spraying. Always keep the spray gun at a right angle

to the work surface.

• Keep the nozzle about 6 to 9 inches from the work surface

throughout the stroke and always keep the gun in motion while

spraying. Stopping gun movement in mid-stroke will cause a

build up of paint and result in runs. Do not fan the gun from side

to side while painting. This will cause a build-up of paint in the

center of the stroke and an insufficient coating at each end.

• Trigger the gun properly. Start the gun moving at the beginning

of the stroke BEFORE SQUEEZING THE TRIGGER. Release

the trigger BEFORE STOPPING GUN MOVEMENT at the end

of the stroke. This procedure will feather (blend) each stroke

with the next without showing overlap or unevenness.

• The amount of paint being applied can be varied by the speed

of the stroke, distance from the surface and adjustment of the

fluid control knob.

• Use a piece of cardboard as a shield to catch overspray at the

edges of the work to protect other surfaces. Use masking tape

to cover other areas if needed.

4008

PRODUCT TYPE:

SPRAY GUN WITH CUP

RED HANDLE 1.8MM NOZZLE

INSTALLATION

1. Cleaning the air hose

• A 1/4" air hose is required, with a maximum length of 25 ft.

• Clean the air hose of accumulated dust and moisture

before connecting it to the air supply.

Note: If a longer air hose is required, connect a 3/8" air

hose to the 1/4" air hose to ensure the spray gun has the

necessary air supply.

2. Connecting to the air supply

• Always use clean dry air. Excessive moisture and dirt will

greatly reduce the life of any air motor. We recommend the

installation of an in-line filter-regulator as close to the

tool as possible.

• Ensure all hoses and fittings are the correct size and

secured tightly.

WARNING: Lubricators should not be used with spray

guns. The use of an inline lubricator will damage

the paint finish.

Recommended Air Line Set-Up

Part

Description

Spray Gun

Regulator

Quick Plug

Quick Coupler

Air Hose

In-line Filter

Air Compressor

Page 3