Air Hogs Havoc Turbo Blast Manuale di avvio rapido - Pagina 2
Sfoglia online o scarica il pdf Manuale di avvio rapido per Giocattolo Air Hogs Havoc Turbo Blast. Air Hogs Havoc Turbo Blast 4.
BATTERY INSTALLATION – CONTROLLER/CHARGER
Make sure the power switch is in the "OFF" position.
1. Use a screwdriver to loosen screw on the battery case counter-clockwise (pic.1)
2. Put 6 AA size batteries in the battery compartment as per the polarity shown inside (pic.2)
3. Tighten the screw clockwise (pic.3)
Battery cover
1. Pull out the cover and take out the charging wire (pic.4).
2. Move the helicopter ON/OFF switch to the "OFF" position to turn the helicopter off. Insert the charging plug into the socket on the bottom of helicopter (pic.5).
3. Move the controller/charger ON/OFF switch to the "ON" position. The red power LED will turn on. When the Red Power LED is flashing the 6 AA batteries in
the controller/charger need to be replaced.
4. The green LED will turn on when charging (pic.6), Once completed, the green LED will turn off. Pull the plug out of the socket on the helicopter.
5. The helicopter will have about 5-6 minutes of flight time after 20-30 minutes charging.
Note: To maximize battery life, wait for 10-15 minutes to let the battery cool down before recharging.
Note: To maximize battery life, wait for 10-15 minutes to let the battery cool down before recharging.
- BE SURE THE CONTROLLER/CHARGER IS "ON" when trimming the helicopter.
- Set the ON/OFF switch on the helicopter to "ON", a light in the helicopter will turn on.
- Place the helicopter on the ground with the tail pointing towards you and the nose facing away from you.
- Set the left stick on the controller/charger all the way down for MINIMUM throttle setting, and then set the power to "ON".
1. TRIMMING YOUR HELICOPTER:
- Gently push the throttle up to raise your helicopter
about 0.5 to 1 meter (1.5 to 3 ft) high.
- If the helicopter spirals clockwise (pic.7) or keeps
turning clockwise (pic.8), push and release the left
side of trim repeatedly till the turning stops and
helicopter flies straight (pic.9).
- If the helicopter spirals counter-clockwise (pic.10)
or keeps turning counter-clockwise (pic.11), push
and release the right side of the trim repeatedly till
the turning stops and the helicopter flies straight
(pic.12).
- The helicopter can be out of trim after some severe or multiple crashes, improper storage or a change in temperature... etc. You can simply solve this problem
following the below procedures.
i) If the helicopter speeds forward by itself:
Step 1:
Take the tail
between fingers.
ii) If the helicopter speeds backward by itself:
Step 1:
Take the tail
between fingers.
HOW TO INSTALL YOUR BATTERIES
pic.1
HOW TO CHARGE YOUR HAVOC
pic.4
HOW TO FLY YOUR HAVOC
Spiral clockwise
Spiral counter-clockwise
pic.2
®
TURBO BLAST™
pic.5
®
TURBO BLAST™
or
pic.7
Keep turning clockwise
or
pic.10
Keep turning counter-clockwise
Step 2:
Twist tail
counter-
clockwise for
about 30°.
Step 2:
Twist tail
clockwise for
about 30°.
pic.3
Battery cover
L
TRIM
pic.8
L
TRIM
pic.11
Step 3:
Release.
90°
Step 3:
Release.
90°
pic.6
R
pic.9
R
pic.12