Air Hogs Havoc Turbo Blast 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Air Hogs Havoc Turbo Blast에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Air Hogs Havoc Turbo Blast 4 페이지.

페이지 인쇄

BATTERY INSTALLATION – CONTROLLER/CHARGER

Make sure the power switch is in the "OFF" position.

1. Use a screwdriver to loosen screw on the battery case counter-clockwise (pic.1)

2. Put 6 AA size batteries in the battery compartment as per the polarity shown inside (pic.2)

3. Tighten the screw clockwise (pic.3)

Battery cover

1. Pull out the cover and take out the charging wire (pic.4).

2. Move the helicopter ON/OFF switch to the "OFF" position to turn the helicopter off. Insert the charging plug into the socket on the bottom of helicopter (pic.5).

3. Move the controller/charger ON/OFF switch to the "ON" position. The red power LED will turn on. When the Red Power LED is flashing the 6 AA batteries in

the controller/charger need to be replaced.

4. The green LED will turn on when charging (pic.6), Once completed, the green LED will turn off. Pull the plug out of the socket on the helicopter.

5. The helicopter will have about 5-6 minutes of flight time after 20-30 minutes charging.

Note: To maximize battery life, wait for 10-15 minutes to let the battery cool down before recharging.

- BE SURE THE CONTROLLER/CHARGER IS "ON" when trimming the helicopter.

- Set the ON/OFF switch on the helicopter to "ON", a light in the helicopter will turn on.

- Place the helicopter on the ground with the tail pointing towards you and the nose facing away from you.

- Set the left stick on the controller/charger all the way down for MINIMUM throttle setting, and then set the power to "ON".

1. TRIMMING YOUR HELICOPTER:

- Gently push the throttle up to raise your helicopter

about 0.5 to 1 meter (1.5 to 3 ft) high.

- If the helicopter spirals clockwise (pic.7) or keeps

turning clockwise (pic.8), push and release the left

side of trim repeatedly till the turning stops and

helicopter flies straight (pic.9).

- If the helicopter spirals counter-clockwise (pic.10)

or keeps turning counter-clockwise (pic.11), push

and release the right side of the trim repeatedly till

the turning stops and the helicopter flies straight

(pic.12).

- The helicopter can be out of trim after some severe or multiple crashes, improper storage or a change in temperature... etc. You can simply solve this problem

following the below procedures.

i) If the helicopter speeds forward by itself:

Step 1:

Take the tail

between fingers.

ii) If the helicopter speeds backward by itself:

Step 1:

Take the tail

between fingers.

HOW TO INSTALL YOUR BATTERIES

pic.1

HOW TO CHARGE YOUR HAVOC

pic.4

HOW TO FLY YOUR HAVOC

Spiral clockwise

Spiral counter-clockwise

pic.2

TURBO BLAST™

pic.5

TURBO BLAST™

pic.7

Keep turning clockwise

pic.10

Keep turning counter-clockwise

Step 2:

Twist tail

counter-

clockwise for

about 30°.

Step 2:

Twist tail

clockwise for

about 30°.

pic.3

Battery cover

TRIM

pic.8

TRIM

pic.11

Step 3:

Release.

90°

Step 3:

Release.

90°

pic.6

pic.9

pic.12