Dot Origin VTAP100 Manuale di installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione per Hardware di rete Dot Origin VTAP100. Dot Origin VTAP100 16. Desktop usb reader
Anche per Dot Origin VTAP100: Manuale di installazione (13 pagine), Manuale di installazione (17 pagine)

Stampa la pagina

This first time, you will need to connect the VTAP100 to your PC, using a USB cable. (If

needed, you can adjust the configuration to make these changes remotely in future, see

VTAP Application Notes.)

Step 1: Upload key file(s) to your VTAP100

1. Ensure each of the keys you need to use are stored in a file with the name

private#.pem, following the .pem format, where # is replaced with a number from 1

to 6, matching the key slot you will save it in. (The demo passes are accessed using the

key in KeySlot 6, so don't overwrite this one unless you are finished with demo passes.)

Note: You cannot use more than 6 key files.

2. Load your keys by copying these files onto your VTAP100, which shows up in the file

system of your PC as a mass storage device.

Note: When you reboot the VTAP100 your key will have been stored in hardware, and

will no longer be listed as a file on the device. You can confirm key file(s) have been

loaded when you Check status in BOOT.TXT. If the key file does not disappear and

there is an error in Boot.txt, check your .pem file as it is likely it did not adhere to the

standard.

VTAP100-USB INSTALLATION GUIDE

VTAP MOBILE WALLET READERS

PAGE 4