Dot Origin VTAP100 설치 매뉴얼 - 페이지 8

{카테고리_이름} Dot Origin VTAP100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dot Origin VTAP100 16 페이지. Desktop usb reader
Dot Origin VTAP100에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 설치 매뉴얼 (17 페이지)

페이지 인쇄

This first time, you will need to connect the VTAP100 to your PC, using a USB cable. (If

needed, you can adjust the configuration to make these changes remotely in future, see

VTAP Application Notes.)

Step 1: Upload key file(s) to your VTAP100

1. Ensure each of the keys you need to use are stored in a file with the name

private#.pem, following the .pem format, where # is replaced with a number from 1

to 6, matching the key slot you will save it in. (The demo passes are accessed using the

key in KeySlot 6, so don't overwrite this one unless you are finished with demo passes.)

Note: You cannot use more than 6 key files.

2. Load your keys by copying these files onto your VTAP100, which shows up in the file

system of your PC as a mass storage device.

Note: When you reboot the VTAP100 your key will have been stored in hardware, and

will no longer be listed as a file on the device. You can confirm key file(s) have been

loaded when you Check status in BOOT.TXT. If the key file does not disappear and

there is an error in Boot.txt, check your .pem file as it is likely it did not adhere to the

standard.

VTAP100-USB INSTALLATION GUIDE

VTAP MOBILE WALLET READERS

PAGE 4