DOTWORKZ HD12-CD-HB Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Telecamera di sicurezza DOTWORKZ HD12-CD-HB. DOTWORKZ HD12-CD-HB 16.

Drilling. Ensure that the holes are marked as accurately as possible. Set the Mounting Plate

aside after marking the drilling locations.

2.1.3

Use a hammer drill to make 3/8 inch diameter holes at each of the 4 mounting locations

marked in the previous step. A hammer drill is required for this operation. Clean the holes

of all concrete dust using a wire brush and compressed air or a vacuum. Install the 3/8-16

concrete anchors in each of the 4 drilled holes by hammering them in to the appropriate

depth. Leave the nut on while hammering so that the threads of the concrete anchor are

protected and not damaged. Ensure that the Mounting Plate fits over the concrete anchors,

and then set it aside.

Warnings:



The supplied anchors are for concrete only. Do not attempt to use in brick, block or other

materials. Other fasteners are required for brick, block and other materials and are not

included. Minimum engagement of the supplied concrete anchors is 2" [50 mm]. If the

provided fasteners are not appropriate for the installation surface, it is the responsibility of

the customer to specify and source appropriate fasteners for the application.



Holes for concrete anchors should be drilled a minimum of 1/2 inch [13 mm] deeper than

the overall length of the anchor, provided that the mounting surface can tolerate such a

depth. This allows the anchor to be hammered flush should a mistake be made or a location

change be necessary.

2.2 Wall Mount

2.2.1

Remove the Wall Mount Cover from the Wall Mount by unscrewing the four 6-32 flat head

screws in the corners of the bracket system. Set the cover and four fasteners aside in a safe

place for later use.

REMOVE SCREWS, 4 PLACES