Baumer HUBNER BERLIN PROFI NET microGen HMG10P Istruzioni per il montaggio e il funzionamento - Pagina 18
Sfoglia online o scarica il pdf Istruzioni per il montaggio e il funzionamento per Convertitore multimediale Baumer HUBNER BERLIN PROFI NET microGen HMG10P. Baumer HUBNER BERLIN PROFI NET microGen HMG10P 40. Incremental encoder with magnetic sensing
Anche per Baumer HUBNER BERLIN PROFI NET microGen HMG10P: Istruzioni per il montaggio e il funzionamento (32 pagine), Manuale operativo (44 pagine)
Stampa la pagina
MOUNTING / HOW TO PREVENT MEASUREMENT ERRORS
4.5
How to prevent measurement errors
To ensure that the device operates correctly, it is necessary to mount it accurately as de-
scribed in section 4�1 to 4�4, which includes correct mounting of the torque arm�
The radial runout of the drive shaft should not exceed 0�2 mm (0�03 mm recommended),
to prevent an angle error�
An angle error may be reduced by increasing the length of L1
L2 of the torque arm, see below, is at least equal to L1
The angle error Δρ
Δρ
= ±90°/π · R/L1
mech
with R: Radial runout in mm
L1:
Example of calculation:
For R = 0.06 mm and L1 = 69.5 mm the resulting angle error Δρ
i
For more information, call the telephone hotline at +49 (0)30 69003-111
For this different support plates for the torque arm are available on request�
1)
If L2 < L1, L2 must be used in the calculation formula�
2)
18/40
can be calculated as follows:
mech
Distance of the torque arm to the center point of the device in mm
MB258EN - 11196411, 21A1, Baumer_HMG10-Inc_EN_202103_MI_11196411
2)
L1
� Make sure that the length
1)
�
equals ±0�025°�
mech