Douglas Dynamics SweepEx Mega-Broom SMB-960 Manuale d'uso e istruzioni per l'installazione - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso e istruzioni per l'installazione per Soffiante Douglas Dynamics SweepEx Mega-Broom SMB-960. Douglas Dynamics SweepEx Mega-Broom SMB-960 14. Modular broom

Stampa la pagina

BRUSH SECTION REPLACEMENT:

1. Suspend the broom by blocks, lift, etc.

2. Remove one end cap.

3. Remove old brush sections.

hose, or air).

5. Insert new brush sections.

6. Replace end cap and fasten securely in place.

BRUSH SECTION ROTATION

After every 4 hours of use, rotate brush sections from

front to back.

STORAGE

Store your broom so that the brush pressure is equal

on all bristle strips. Some suggestions are:

• Block both ends so that the weight of the unit is not

on the brush strips at all.

• Store broom upside down.

• Store blocked so that broom sits level.

This will preserve an EVEN sweeping surface. Store

under a dark tarp to minimize ultraviolet light damage

to brush sections.

Lit. No. 48166, Rev. 00

MAINTENANCE

BRISTLE WEAR

All SweepEx

application, will work equally well sweeping backward

or forward.

If you only sweep in one direction, the bristles

eventually will knife to a point. Using the broom for

"forward only" sweeping will cause the broom to start

losing its effectiveness. Pulling the bristle rows out of

the hood and turning them around end for end will give

more even wear. Once the bristles are worn down to

approximately 50% of their original height, the entire

set should be replaced.

As the bristles wear down, they may become stiff and

tips and result in an undesirable smear. Generally

speaking, SweepEx bristles wear out or melt, due

to ground friction, at a rate of 1/64" per mile. This, of

course, should be monitored case by case. Individual

use and wear may vary.

For any questions, call 1-877-SweepEx

brooms, regardless of their size and

October 15, 2014