Dahua SERIES Installazione, avvio rapido - Pagina 3

Sfoglia online o scarica il pdf Installazione, avvio rapido per Interruttore Dahua SERIES. Dahua SERIES 4.

Measure the distance between the

two cross-shaped mounting holes.

Drill two holes with a diameter of 6 mm (0.24 in) and depth of 25 mm (0.98 in) in the wall.

Hammer a screw anchor into each hole. Use a Phillips screwdriver to drive the screw into

each screw anchor, leaving 1.5 mm (0.06 in) between the screw head and the wall for

hanging the switch.

25 mm

(0.98 in)

Connecting the grounding cable

Correctly connecting the grounding cable is crucial to lightning protection and EMI protection. Use the

grounding cable provided with the switch for grounding.

Mark the installation holes on the wall. Make

sure the two installation holes are on the same

horizontal line

1.5 mm

(0.06 in)

Connect the grounding cable to the switch

Installing a power module

This section is applicable only to switch models that use removable power modules.

Remove a filler panel (skip this step if no filler panel is in the power module slot)

Connecting the power cord

For switch models with removable power modules, make sure the power modules are installed

correctly before connecting a power cord.

Before connecting the power cord, make sure the switch is reliably grounded.

To avoid bodily injury, connect the power cord first to the switch and then to the equipment-room

power supply system.

The number of cable ties and installation positions of the cable ties (if provided) depend on the

switch model.

The power cord varies by power module. Do not mix power cords.

Method 1

Connect the grounding cable to a grounding strip