Dahua SERIES Installazione, avvio rapido
Sfoglia online o scarica il pdf Installazione, avvio rapido per Interruttore Dahua SERIES. Dahua SERIES 4.
Stampa la pagina
Installation tools
No installation tools are provided with the switch. Prepare them yourself as required.
Phillips screwdriver
Diagonal pliers
ESD wrist strap
Marker
Safety recommendations
To avoid any equipment damage or bodily injury during installation, read the following safety
recommendations carefully before installation. Note that the recommendations do not cover
every possible hazardous condition.
Make sure the environmental conditions such as voltage, temperature, and humidity at the installation
!
site meet the device requirements.
Make sure the installation site is well-ventilated. Keep the air vents of the switch free of obstruction
during switch operation.
Place the switch in a location away from the interference sources.
Wear an ESD wrist strap during the installation. Make sure the wrist strap makes good skin contact
and is reliably grounded.
To avoid body injury and device damage, power on the switch after the switch is reliably grounded.
Install a filler panel in each unused slot to ensure good ventilation.
Installation accessories
The applicable installation accessories vary by switch model. The packing list describes the
accessories provided with the switch. For the accessories not provided with the switch, purchase
them yourself as required.
To rack-mount a switch not provided with mounting brackets, purchase mounting brackets from
Dahua.
M6 screw and cage nut
Rubber feet
Dahua Switch Series Installation Quick Start-APW100
Dahua Switch Series Installation Quick Start-APW100
Needle-nose pliers
Rubber hammer
Grounding cable
Type A front mounting
bracket and screw
Wire stripper
Screw anchor
and screw
Mounting the switch in a rack
1
Using front mounting brackets
This installation method is not applicable to a switch provided with both front and rear mounting
!
brackets.
The applicable front mounting brackets and the installation positions for the brackets vary by switch
model. Select an installation position for the mounting brackets as required.
A Type A front mounting bracket requires four screws to attach to the switch. A Type B, Type C,
or Type D mounting bracket requires two screws to attach to the switch.
Attach the front mounting brackets to the switch
Attach a Type A front
mounting bracket near the port
side
Cable tie
Product code:
SOHO-SWITCH-FL-02
Type B front mounting
Type C front mounting
bracket and screw
bracket and screw
Rear mounting bracket
and shoulder screw
Attach a Type A front mounting
bracket near the power module
side
BOM: 3101A0N9
Product code:
SOHO-SWITCH-FL-01
Type D front mounting
bracket and screw
Attach a Type B front
mounting bracket near the
port side