Dahua SERIES Установка, быстрый старт

Просмотреть онлайн или скачать pdf Установка, быстрый старт для Переключатель Dahua SERIES. Dahua SERIES 4 страницы.

Печатать страницу

Installation tools

No installation tools are provided with the switch. Prepare them yourself as required.

Phillips screwdriver

Diagonal pliers

ESD wrist strap

Marker

Safety recommendations

To avoid any equipment damage or bodily injury during installation, read the following safety

recommendations carefully before installation. Note that the recommendations do not cover

every possible hazardous condition.

Make sure the environmental conditions such as voltage, temperature, and humidity at the installation

site meet the device requirements.

Make sure the installation site is well-ventilated. Keep the air vents of the switch free of obstruction

during switch operation.

Place the switch in a location away from the interference sources.

Wear an ESD wrist strap during the installation. Make sure the wrist strap makes good skin contact

and is reliably grounded.

To avoid body injury and device damage, power on the switch after the switch is reliably grounded.

Install a filler panel in each unused slot to ensure good ventilation.

Installation accessories

The applicable installation accessories vary by switch model. The packing list describes the

accessories provided with the switch. For the accessories not provided with the switch, purchase

them yourself as required.

To rack-mount a switch not provided with mounting brackets, purchase mounting brackets from

Dahua.

M6 screw and cage nut

Rubber feet

Dahua Switch Series Installation Quick Start-APW100

Needle-nose pliers

Rubber hammer

Grounding cable

Type A front mounting

bracket and screw

Wire stripper

Screw anchor

and screw

Mounting the switch in a rack

Using front mounting brackets

This installation method is not applicable to a switch provided with both front and rear mounting

brackets.

The applicable front mounting brackets and the installation positions for the brackets vary by switch

model. Select an installation position for the mounting brackets as required.

A Type A front mounting bracket requires four screws to attach to the switch. A Type B, Type C,

or Type D mounting bracket requires two screws to attach to the switch.

Attach the front mounting brackets to the switch

Attach a Type A front

mounting bracket near the port

side

Cable tie

Product code:

SOHO-SWITCH-FL-02

Type B front mounting

Type C front mounting

bracket and screw

Rear mounting bracket

and shoulder screw

Attach a Type A front mounting

bracket near the power module

side

BOM: 3101A0N9

Product code:

SOHO-SWITCH-FL-01

Type D front mounting

bracket and screw

Attach a Type B front

mounting bracket near the

port side