Doxmand VR4 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Disinfestazione Doxmand VR4. Doxmand VR4 4. Ultrasonic wild animal repellent

Stampa la pagina

Beeps:

The states of charge indicator (first 1-3 beeps at power-on)

●

3 beeps

●

2 beeps

●

1 beep

If the device is charging from an external unit, a higher frequency sound after the charge status indicator will indicate that the external charging unit is

connected.

●

3 beeps – For 12.3-14V outdoor unit

●

2 beeps – For 10.3-12.2V outdoor unit

●

1 beep – For 5-10.2V external unit

Light signals:

When the LED is lit, the device is switched on.

When the LED is off, the device is switched off.

IMPORTANT! The alarm is strongest with 3 beeps and weakens with 2 beeps. In the event of one beep, the device will no longer sound an alarm,

preventing the Li-ion battery cell from being discharged excessively, which would cause damage. It will reactivate after the next sunny period.

When charging externally from a 12V battery, the device protects the battery from discharging, so if the battery voltage drops below 10.2V, the device

automatically disconnects it, charging stops, thus protecting the battery from excessive discharge.

THE SOLAR PANEL CHARGES THE BATTERY ONLY WHEN IT IS TURNED ON!

If there is a protective film on the solar panel, it is advisable to remove it before using the product for the first time, as after a while the Sun may

burn it, which can make it difficult to remove and affect the proper energy consumption!

2.3 EXTERNAL SOLAR PANEL

There is a connector under the device which may connect the additional solar panel. This can be a solution for charging problems in the winter time.

When the number of sunny hours is lower or there is snow on the solar panel. Additional solar panels are not included, they are optional.

3. CLEANING AND MAINTENANCE

IMPORTANT! Do not immerse the device in water! Do not use a strong detergent, abrasive scrubber to clean the appliance! Clean the device with a

damp, soft cloth. Over time, the solar cell may become whitish and become scale-coated, affecting the power supply of the device. It is therefore advisable

to wipe it occasionally, for example by cleaning it with a recommended WD-40 or limescale cleaning agent.

4. STORAGE

IMPORTANT! When using the device periodically, please comply with the appropriate storage conditions for a longer lifetime! If the battery charge is too

low or too high, you can shorten the battery life. Its storage temperature is recommended between (-)20 and (+)25 °C. Always turn off the device when

not in use, store it in a closed environment!

Before putting it on the shelf, it is recommended to clean the device as described above. Check the battery charge! Turn it off and then on again to see

how many beeps you hear when you turn it back on. The device should be stored with a medium charged battery, so you should hear exactly 2 beeps

when you turn it back on. If you hear exactly two beeps, turn it off and you can put the device away.

If you hear 3 beeps, cover the solar panel while it is on and after a few hours try to turn it on and off again. Repeat until you hear 2 beeps when turning

on. If you only hear one beep, put it to the sun when it is turned on and let it charge. After a few hours try to turn it on and off again. Repeat until you

hear 2 beeps when turning on.

5. TROUBLESHOOTING

Before contacting a service center, please check the following options:

PROBLEM

The effect of the alarm is weakened.

Low battery level (1 beep).

6. WASTE MANAGEMENT

Protect our environment!

Do not dispose of electrical equipment as household waste! Keep the

packaging materials out of the reach of small children as these may be

dangerous to them! Collect the packaging materials selectively!

If electrical equipment is landfilled, hazardous substances can leak into the

groundwater, causing damage to our health and well-being through entering

the food chain.

Fully charged status.

Medium charged status.

Low power, waiting for sunshine.

The solar cell is not exposed to sufficient

sunlight.

The battery is only charged when the device is

turned on!

POSSIBLE CAUSE

7. DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT

Disposal of this product may be carried out in any electronic waste collector.

Electrical equipment may contain components that are hazardous to the

environment.

The environment is the heritage of our grandchildren, the

preservation of it is therefore the common interest and

responsibility of all of us, so I ask you to help this endeavor!

DOXMAND HUNGARY LTD.

Doxmand VR4 User Manual

POSSIBLE SOLUTION

It is recharged to the appropriate level with

sunlight, but if it still gives you only 1 signal,

contact our customer service.

v.1.2