Doxmand VR4 Kullanıcı Kılavuzu - Sayfa 4
Haşere Kontrol Doxmand VR4 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Doxmand VR4 4 sayfaları. Ultrasonic wild animal repellent
Beeps:
The states of charge indicator (first 1-3 beeps at power-on)
●
3 beeps
●
2 beeps
●
1 beep
If the device is charging from an external unit, a higher frequency sound after the charge status indicator will indicate that the external charging unit is
connected.
●
3 beeps – For 12.3-14V outdoor unit
●
2 beeps – For 10.3-12.2V outdoor unit
●
1 beep – For 5-10.2V external unit
Light signals:
-
When the LED is lit, the device is switched on.
-
When the LED is off, the device is switched off.
IMPORTANT! The alarm is strongest with 3 beeps and weakens with 2 beeps. In the event of one beep, the device will no longer sound an alarm,
preventing the Li-ion battery cell from being discharged excessively, which would cause damage. It will reactivate after the next sunny period.
When charging externally from a 12V battery, the device protects the battery from discharging, so if the battery voltage drops below 10.2V, the device
automatically disconnects it, charging stops, thus protecting the battery from excessive discharge.
THE SOLAR PANEL CHARGES THE BATTERY ONLY WHEN IT IS TURNED ON!
If there is a protective film on the solar panel, it is advisable to remove it before using the product for the first time, as after a while the Sun may
burn it, which can make it difficult to remove and affect the proper energy consumption!
2.3 EXTERNAL SOLAR PANEL
There is a connector under the device which may connect the additional solar panel. This can be a solution for charging problems in the winter time.
When the number of sunny hours is lower or there is snow on the solar panel. Additional solar panels are not included, they are optional.
3. CLEANING AND MAINTENANCE
IMPORTANT! Do not immerse the device in water! Do not use a strong detergent, abrasive scrubber to clean the appliance! Clean the device with a
damp, soft cloth. Over time, the solar cell may become whitish and become scale-coated, affecting the power supply of the device. It is therefore advisable
to wipe it occasionally, for example by cleaning it with a recommended WD-40 or limescale cleaning agent.
4. STORAGE
IMPORTANT! When using the device periodically, please comply with the appropriate storage conditions for a longer lifetime! If the battery charge is too
low or too high, you can shorten the battery life. Its storage temperature is recommended between (-)20 and (+)25 °C. Always turn off the device when
not in use, store it in a closed environment!
Before putting it on the shelf, it is recommended to clean the device as described above. Check the battery charge! Turn it off and then on again to see
how many beeps you hear when you turn it back on. The device should be stored with a medium charged battery, so you should hear exactly 2 beeps
when you turn it back on. If you hear exactly two beeps, turn it off and you can put the device away.
If you hear 3 beeps, cover the solar panel while it is on and after a few hours try to turn it on and off again. Repeat until you hear 2 beeps when turning
on. If you only hear one beep, put it to the sun when it is turned on and let it charge. After a few hours try to turn it on and off again. Repeat until you
hear 2 beeps when turning on.
5. TROUBLESHOOTING
Before contacting a service center, please check the following options:
PROBLEM
The effect of the alarm is weakened.
Low battery level (1 beep).
6. WASTE MANAGEMENT
Protect our environment!
Do not dispose of electrical equipment as household waste! Keep the
packaging materials out of the reach of small children as these may be
dangerous to them! Collect the packaging materials selectively!
If electrical equipment is landfilled, hazardous substances can leak into the
groundwater, causing damage to our health and well-being through entering
the food chain.
Fully charged status.
Medium charged status.
Low power, waiting for sunshine.
The solar cell is not exposed to sufficient
sunlight.
The battery is only charged when the device is
turned on!
POSSIBLE CAUSE
7. DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
Disposal of this product may be carried out in any electronic waste collector.
Electrical equipment may contain components that are hazardous to the
environment.
The environment is the heritage of our grandchildren, the
preservation of it is therefore the common interest and
responsibility of all of us, so I ask you to help this endeavor!
4
4
/
DOXMAND HUNGARY LTD.
Doxmand VR4 User Manual
POSSIBLE SOLUTION
It is recharged to the appropriate level with
sunlight, but if it still gives you only 1 signal,
contact our customer service.
v.1.2