Ampro NEO 300 BEAM Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per DJ Ampro NEO 300 BEAM. Ampro NEO 300 BEAM 18. Moving head

Lamp: Switch on the light bulb. After changing
the value, wait about 3 seconds to work. You can
switch the value back within 3 seconds and cancel
the operation. After turning off the bulb, you must
wait for 1~2 minutes before turning it on again.
If the operation menu is turned on within two
minutes, the bulb will not be lit. When the waiting
time reaches, it will light on itself.
item is on, the system tries to light the bulb and
waits for the lighting board to return.
Manual operation: Set the value of the channel
manually.
Channel 1: Set up the DMX channel 1
Channel 2: Set up the DMX channel 2
Channel 3: Set up the DMX channel 3
Run Settings: Run the parameter settings.
Master/Slave Mode :Set the master from mode
Pan & Tilt General settings:
Pan Invert: Select Yes, reverse the rotation
direction of the Pan motor, select No,
and press
the rotation direction at the factory.
Tilt Invert: Select Yes,reverse the rotation
direction of the Tilt motor,selectNo,and press
the rotation direction at the factory.
Pan setting:
Starting range: 0-254
End range: 0-255
Tilt setting:
Starting range: 0-254
End range: 0-255
Color linearity:
Select Yes, the color disk linear step.
The dimming curve: Select a dimmer curve
(LED-only).
No signal: Select how if the DMX512 signal is not
detected.
P. 10
English Version | NEO 300 BEAM
Starting up: The above operating mode is
performed only, if the DMX signal is not detected,
while on startup, otherwise, the last DMX action
will be maintained.
If the menu
Run time: At any moment, whenever the DMX signal
of the action is lost.
- Hold the last-frame DMX value.
- Closed light Turn off the light switch.
Display settings: Settings for the LCD LCD screen.
Boot bright bubble: Select "No", do not light the
light after the boot reset completes, select "Yes",
and automatically light the bulb after the boot
reset completes.
Advanced Settings:
Adj:Factory debugging function,
requires password verification to enter.
Language: Set the system language.
Stand-in dormancy: Set the action of
the functional motor when turning off the
bulb."Hibernate" means cutting power off all
functional motors (Pan and Tilt motors do not cut
off and can still operate normally).
No signal waiting:Set how long the no-
DMX signal will enter hibernation mode.
Shut up and wait:Sets how long the light closes
and into Hibernate mode.
Closed light threshold:Set the closed light
judgment threshold, that is, the closed light is
considered only when the dimming channel is
less than this value.
Mediacy: Except for Pan and Tilt, all other
channels are cleared.
Self-walk (factory test / pattern / color).
Run the programs set up by the manufacturer
User program:Run the user self-programming
program.