Ampro NEO 300 BEAM Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per DJ Ampro NEO 300 BEAM. Ampro NEO 300 BEAM 18. Moving head

5 ALIGNMENT, INSTALLATION OR REPLACEMENT OF A LAMP

- Loosen and remove screws B,C and D .Loosen screw A which can only be loosened but can't be removed, for

details please see the figure on the right. Then the lamp and its supporting frames can be seen.

- Loosen screws E and F and push the lamp supporting frames downward to expose the lamp's side, and

remove the lamp after pushing it downward. After unplugging the lamp, remove it. Plug a new lamp with lamp

wires after it is in place, push the supporting frames upward and tighten the screws to fix the new lamp.

Tighten the screws after the lamp chamber cover is on.

At last restore the projector's original appearance based on the opposite sequences of dismantling.

6. SET UP AND CONFIGURATION

1 USING THE FRONT PANEL

•

Unlock way: Press the left and right keys

simultaneously for 5 seconds simultaneously.

•

DMX Address: Set up the DMX address.

•

Channel mode: Set the channel mode, and the

numbers of the menu options represent the

channel 8.

•

Rest: Reset the motor.

•

Motor power failure: Select On, all motors

power off; select off, all motors power on and

reset. With this menu, you can plug and reset

the motor without closing the main switch.

XY: Rest Pan andTilt motor ......

UPPER

LEFT

LOWER

•

Run: Set up the operation mode.

The menu options are described as follows.

(Note: Self Walk mode options may vary

according to product model).

DMX Run by the DMX512 console control.

Self-walk (factory testing): Run a program set

by the manufacturer which is mainly used for

factory testing.

Self-programming program. You can set

the editing scene in the [Run Settings] - [Self

programming] menu.

RIGHT

P. 9

English Version | NEO 300 BEAM