Amprobe AT-6010 Manuale di avvio rapido - Pagina 7

Sfoglia online o scarica il pdf Manuale di avvio rapido per GPS Amprobe AT-6010. Amprobe AT-6010 12. Advanced wire tracer

Special Application: Finding Shorts

Set-up:

Transmitter

Verify the

Loop LED

is ON.

1. Connect the Transmitter with the test leads

to the circuit.

2. Switch the Transmitter to Loop mode by

short press of On/Off button. Verify that the

Loop LED is ON.

Tracing mode:

Tracing a cable to find shorts

1. Start tracing the cable until the signal stops.

2. Verify the place of the fault: move the

Transmitter to the other end of the wire and

repeat tracing from the opposite end. If the

signal stops at the exact same location the

fault has been located.

Advanced Wire Tracer - Quick Guide

Set-up:

Receiver

1. Turn on the Receiver. Tracing mode is

automatically activated.

Note:

This method will be affected

by signal cancellation effect. Expect

a relatively weak signal.