Amprobe AT-6010 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Amprobe AT-6010에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Amprobe AT-6010 12 페이지. Advanced wire tracer

Special Application: Finding Shorts

Set-up:

Transmitter

Verify the

Loop LED

is ON.

1. Connect the Transmitter with the test leads

to the circuit.

2. Switch the Transmitter to Loop mode by

short press of On/Off button. Verify that the

Loop LED is ON.

Tracing mode:

Tracing a cable to find shorts

1. Start tracing the cable until the signal stops.

2. Verify the place of the fault: move the

Transmitter to the other end of the wire and

repeat tracing from the opposite end. If the

signal stops at the exact same location the

fault has been located.

Advanced Wire Tracer - Quick Guide

Set-up:

Receiver

1. Turn on the Receiver. Tracing mode is

automatically activated.

Note:

This method will be affected

by signal cancellation effect. Expect

a relatively weak signal.