Bosch DISHWASHER Manuale di istruzioni per l'installazione - Pagina 8

Plumbing Preparation

PLUMBING PREPARATION

WARNING: SCALD HAZARD -

Serious injury could result if work is

performed on a charged hot water line.

Only qualified plumbers should perform

plumbing work. Do not attempt any work on

14"

the dishwasher hot water supply plumbing

(355mm)

until you are certain the hot water supply is

shut off.

CAUTION: Temperatures required for soldering

and sweating will damage the dishwasher's base

and water inlet valve. If plumbing lines are to be

Figure 7

soldered or sweated, keep the heat source at

least 6 inches (152.4 mm) away from the

dishwasher's base and water inlet valve.

Hot Water Supply

The hot water heater should be set to deliver approximately

120° F (49° C) water to the dishwasher. Water that is too

hot can cause some detergents to lose effectiveness.

Lower water temperatures will increase run times.

The hot water supply pressure must be between 15 - 145

psi (1 - 10 bars).

Hot Water Supply Plumbing

Install an easily accessible shut-off valve (not supplied) in

the hot water supply line, as shown in Figure 7, letter B.

All solder connections must be made before the water line

is connected to the dishwasher's water inlet valve. Water

may also be supplied to the dishwasher by using a braided

hose line. Check with your local plumbing supply sources

for the proper hose and 90° elbow fitting.

NOTE: Regardless of where the hot water supply line

enters the enclosure (following the guidelines on page 8),

position the line 14" (355mm) from the enclosure's left

side, as shown in Figure 7, letter A.

NOTE: Decide whether braided hose or copper tubing will

be used for the hot water supply plumbing, and purchase

the correct type of hot water supply shut-off valve, 90°

elbow, and necessary fittings for the hot water supply

plumbing.

(Continued on next page)