Draper BS190 Manuale di istruzioni - Pagina 13

Sfoglia online o scarica il pdf Manuale di istruzioni per Sega Draper BS190. Draper BS190 20. Two wheel bandsaw
Anche per Draper BS190: Manuale di istruzioni per l'uso (20 pagine)

Stampa la pagina

ASSEMBLY cont'd

To adjust the height, loosen the upper slide lock

knob ✲✌ Fig.18. and slide the guide assembly into

position. When correctly positioned, re-tighten the

lock knob ✲✌.

INSTALLING A BLADE

NOTE: Turn the saw off and disconnect from the

power supply before removing or installing a blade.

1. Loosen the upper slide lock knob and position

the guide assembly approximately half way

between the table and the frame. Tighten the

lock knob.

2. Open the front cover ✳✌ Fig.19. of the bandsaw

by loosening the two lock knobs ✴✌ using a

plain slot screwdriver.

Loosen the two blade guard mounting screws ✵✌

Fig.20. and remove the blade guard ✶✌.

4. Now remove the table alignment screw ✯✌

washer and wing nut ✰✌ from the table.

(See Fig.16).

Slide the blade into the slot in the table ✷✌

Fig.21. ensuring that the teeth are facing

forwards and downwards towards the worktable.

Install the blade with the tension adjusting knob

in the compressing position.

7. Place the blade over both wheels, as shown in

Fig.21. Now centre the blade on the rubber

wheel tyres ✸✌.

IMPORTANT NOTE: Please refer to BLADE BRUSH on

page 18 "MAINTENANCE".

Fig.18.

Fig.19.

✳✌

✵✌

- 13 -

✲✌

✴✌

✶✌

Fig.20.

Fig.21.

✸✌

✷✌