Draper BS190 사용 설명서 - 페이지 13

{카테고리_이름} Draper BS190에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper BS190 20 페이지. Two wheel bandsaw
Draper BS190에 대해서도 마찬가지입니다: 사용 설명서 지침 (20 페이지)

ASSEMBLY cont'd

To adjust the height, loosen the upper slide lock

knob ✲✌ Fig.18. and slide the guide assembly into

position. When correctly positioned, re-tighten the

lock knob ✲✌.

INSTALLING A BLADE

NOTE: Turn the saw off and disconnect from the

power supply before removing or installing a blade.

1. Loosen the upper slide lock knob and position

the guide assembly approximately half way

between the table and the frame. Tighten the

lock knob.

2. Open the front cover ✳✌ Fig.19. of the bandsaw

by loosening the two lock knobs ✴✌ using a

plain slot screwdriver.

Loosen the two blade guard mounting screws ✵✌

Fig.20. and remove the blade guard ✶✌.

4. Now remove the table alignment screw ✯✌

washer and wing nut ✰✌ from the table.

(See Fig.16).

Slide the blade into the slot in the table ✷✌

Fig.21. ensuring that the teeth are facing

forwards and downwards towards the worktable.

Install the blade with the tension adjusting knob

in the compressing position.

7. Place the blade over both wheels, as shown in

Fig.21. Now centre the blade on the rubber

wheel tyres ✸✌.

IMPORTANT NOTE: Please refer to BLADE BRUSH on

page 18 "MAINTENANCE".

Fig.18.

Fig.19.

✳✌

✵✌

- 13 -

✲✌

✴✌

✶✌

Fig.20.

Fig.21.

✸✌

✷✌