Draper CSM355 Manuale di istruzioni - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per Sega Draper CSM355. Draper CSM355 16. 355mm dry metal cutting saw
Stampa la pagina
ADDITIONAL SAFETY RULES
FOR METAL CUTTING SAW
1. WARNING: Do not operate your metal
cutting saw until it is completely
assembled and installed according to the
instructions.
2. IF YOU ARE NOT thoroughly familiar with
the operation of the metal cutting saw,
obtain advice from your supervisor,
instructor or other qualified person.
3. WEAR safety goggles, face shield,
respirator, body apron, head covering,
safety shoes, long tight - fitting sleeves
and gloves.
4. BE SURE blade is sharp, runs freely and is
free of vibration.
5. TIGHTEN arbor screw and all clamps
before operating.
6. MAKE SURE spindle lock is disengaged
before operating.
7. ALWAYS keep guards in place and
working properly.
8. KEEP hands out of path of saw blade.
9. SECURE workpiece properly.Work should
be straight and firmly clamped to avoid
possible movement and pinching as the
cut nears completion.
10. NEVER cut anything freehand.
11. NEVER reach behind or beneath the
blade.
12. MAKE SURE the blade has come to a
complete stop before removing or
securing workpiece or changing
workpiece angle.
13. BE SURE blade and flanges are clean and
that arbor screw is tightened securely.
14. NEVER use blades larger or smaller in
diameter than recommended.
15. USE ONLY blades rated at 1500rpm or
higher.
16. ALWAYS check the blade for cracks or
other damage before operation. Replace
cracked or damaged blade immediately.
17. USE ONLY blade flanges specified for
your machine.
18. MAKE SURE blade is not contacting
workpiece before switch is turned on.
19. ALLOW the motor to come up to full
speed before starting cut.
20. AFTER TURNING MACHINE ON, lower
wheel lightly until it comes into contact
with the workpiece and then draw blade
firmly through the cut. DO NOT force the
blade through the workpiece. This will
result in poor cutting and damage the TCT
teeth.
21. ALWAYS keep the lower blade guard in
place.
22. IMPORTANT: After completing cut,
release powerswitch and wait for coasting
blade to stop before returning saw to
raised position.
23. USE the blade guard at all times.
24. NEVER operate the machine in an area
with flammable liquid or gases.
25. TO AVOID electric shock, do not use
under damp conditions or expose to rain.
26. PROVIDE adequate support to the sides
of the saw table for long workpieces.
27. DISCONNECT FROM POWER SUPPLY
before servicing or adjusting tool.
28. SHOULD any part of your machine be
missing, damaged or fail in any way, or any
electrical component fail to perform
properly, shut-off switch and remove plug
from power supply outlet. Replace
missing, damaged or failed parts before
resuming operation.
29. SAVE THESE INSTRUCTIONS. Refer to
them often and use them to instruct others.
- 5 -