Draper FlexShade Istruzioni Installazione e funzionamento - Pagina 4

Sfoglia online o scarica il pdf Istruzioni Installazione e funzionamento per Arredamento per interni Draper FlexShade. Draper FlexShade 4. Exterior clutch-operated shade
Anche per Draper FlexShade: Manuale di installazione e funzionamento (8 pagine), Istruzioni per l'installazione (2 pagine), Manuale di istruzioni (12 pagine), Istruzioni per l'installazione e il funzionamento (11 pagine), Istruzioni Installazione e funzionamento (12 pagine), Istruzioni Installazione e funzionamento (16 pagine), Manuale di istruzioni (7 pagine), Istruzioni Installazione e funzionamento (12 pagine), Istruzioni Installazione e funzionamento (16 pagine)

Stampa la pagina
Draper FlexShade Istruzioni Installazione e funzionamento
Cordless FlexShade
Section 4 - Adjusting Shade Tension
Please Note: If shade has too much tension
little
, tension level can be adjusted.
(does not reach the top)
1. Locate the acrylic tension or adjustment screws on shade's headrail.
2. If shade is in a metal valance, first remove the endcap on the valance.
3. If shade is in an upholstered valance, it may be necessary to first
remove the shade from the valance
Regular Roll:
Please Note: Adjustments can be made to the
screw to the LEFT hand side of shade.
1. Using a cross head or flat head screwdriver,
turn the screw until the desired tension is
reached.
2. Turning clockwise will LOWER the upper
limit.
3. Turning counter clockwise will RAISE the
upper limit.
Reverse Roll:
Please Note: Adjustments can be made on the
screw to the RIGHT hand side of shade.
1. Using a cross head or flat head screwdriver,
turn the screw until desired tension is
reached.
2. Turning clockwise will INCREASE tension.
3. Turning counter clockwise will DECREASE
tension.
®
or too
(springs up too quickly)
.
(Section 3)
Section 5 - Adjusting Shade Upper Limit
Please Note: Upon retracting shade, if it does not stop at a satisfactory
upper limit, the upper limit can be adjusted.
1. Locate the acrylic tension or adjustment screws on shade's headrail.
2. If shade is in a metal valance, first remove the endcap on the valance.
3. If shade is in an upholstered valance, it may be necessary to first
remove the shade from the valance
Regular Roll:
Please Note: Adjustments can be made to the
screw to the RIGHT hand side of shade.
1. Using a cross head or flat head screwdriver,
turn the screw until the desired tension is
reached.
2. Turning clockwise will LOWER the upper
limit.
3. Turning counter clockwise will RAISE the
upper limit.
Reverse Roll:
Please Note: Adjustments can be made on the
screw to the LEFT hand side of your shade.
1. Using a cross head or flat head screwdriver,
turn the screw until desired tension is
reached.
2. Turning clockwise will LOWER upper limit.
3. Turning counter clockwise will RAISE
upper limit.
page 4 of 4
.
(Section 3)