Electrolux EW 1035 F Libretto di istruzioni - Pagina 23
Sfoglia online o scarica il pdf Libretto di istruzioni per Lavatrice Electrolux EW 1035 F. Electrolux EW 1035 F 25.
Anche per Electrolux EW 1035 F: Libretto di istruzioni (22 pagine), Libretto di istruzioni (27 pagine)
Stampa la pagina
Something not working?
Problems which you can resolve yourself.
During the machine operation it is possible that the "Fin" light flashes:
- 4 flashes: door open
- 2 flashes: the water is not drained
- 1 flash: there is no water fill
Once the problem has been eliminated, press the "Inicio/Pausa" button to restart the programme. If after all
checks, the problem persists, contact your local Service Force.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty
and/or does not spin:
• There is water on the floor:
• Unsatisfactory washing results:
• The machine vibrates or is
noisy:
Possible cause
• The door is not firmly closed.
• The machine is not plugged in or there is no power
at the socket.
• The main fuse has blown.
• The programme selector dial is not positioned
correctly.
• The "Inicio/Pausa" (Start/Pause) button has not
been depressed.
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage" section.
• The drain hose is squashed or kinked.
• The option "Antiarrugas" or
• The drain pump is clogged.
• Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
been replaced after cleaning the filter.
• The pump has not been fully screwed in after
cleaning.
• Too little detergent or unsuitable detergent has
been used.
• Stubborn stains have not been treated prior to
washing.
• The correct programme/temperature was not
selected.
• Excessive laundry load.
• The transit bolts and packing have not been
removed.
• The support feet have not been adjusted.
• The laundry is not evenly distributed in the drum.
• Maybe there is very little laundry in the drum.
46
has been selected.