Electrolux EW 1035 F 지침 책자 - 페이지 23

{카테고리_이름} Electrolux EW 1035 F에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux EW 1035 F 25 페이지.
Electrolux EW 1035 F에 대해서도 마찬가지입니다: 지침 책자 (22 페이지), 지침 책자 (27 페이지)

페이지 인쇄

Something not working?

Problems which you can resolve yourself.

During the machine operation it is possible that the "Fin" light flashes:

- 4 flashes: door open

- 2 flashes: the water is not drained

- 1 flash: there is no water fill

Once the problem has been eliminated, press the "Inicio/Pausa" button to restart the programme. If after all

checks, the problem persists, contact your local Service Force.

Problem

• The machine does not start up:

• The machine does not fill:

• The machine fills then empties

immediately:

• The machine does not empty

and/or does not spin:

• There is water on the floor:

• Unsatisfactory washing results:

• The machine vibrates or is

noisy:

Possible cause

• The door is not firmly closed.

• The machine is not plugged in or there is no power

at the socket.

• The main fuse has blown.

• The programme selector dial is not positioned

correctly.

• The "Inicio/Pausa" (Start/Pause) button has not

been depressed.

• The water tap is closed.

• The inlet hose is squashed or kinked.

• The filter in the inlet hose is blocked.

• The door is not properly closed.

• The end of the drain hose is too low. Refer to

relevant paragraph in "water drainage" section.

• The drain hose is squashed or kinked.

• The option "Antiarrugas" or

• The drain pump is clogged.

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• The cap on the emergency emptying hose has not

been replaced after cleaning the filter.

• The pump has not been fully screwed in after

cleaning.

• Too little detergent or unsuitable detergent has

been used.

• Stubborn stains have not been treated prior to

washing.

• The correct programme/temperature was not

selected.

• Excessive laundry load.

• The transit bolts and packing have not been

removed.

• The support feet have not been adjusted.

• The laundry is not evenly distributed in the drum.

• Maybe there is very little laundry in the drum.

has been selected.