Airstar SIROCCO REDTECH 700 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di illuminazione Airstar SIROCCO REDTECH 700. Airstar SIROCCO REDTECH 700 8.

Make sure there is sufficient space in the installation area to allow the balloon to be inflated and to prevent the product from

tipping over when inflating.

NOTE:

•

Always use AIRSTAR-approved stands designed to work with your Sirocco unit.

•

Always securely tighten all T-Handles to avoid injury.

•

Stands are designed for vertical mounting of Sirocco units ONLY.

⇒ Unfold the stand.

⇒ Lock the base in place.

⇒ On the optional stand P500AH (Fig. 4), lift the outer cylinder at the base slightly, then hook the oval locking ring over the safety

hook.

⇒ On the optional stand P500TA, slide the stand legs out from the folded position until the support bars are exactly horizontal.

⇒ On the P500AH (Fig. 4), weights must be placed on each foot at 24 in (60 cm) from the center of the stand.

⇒ On the P500TA (Fig. 5), weights must be placed on each support at 20 in (50 cm) from the center of the stand.

⇒ Follow this correlation table (indicative for a flat floor and a steady wind)

⇒ Guy ropes are the only way to ensure the safety of the light stand in strong or gusty wind.

⇒ In the case of an uneven surface or sloping ground, the stand column must remain vertical and the tripod legs must rest on a

solid surface.

Fig. 4

24 in

Load

18-07-2022 / A-00222-A

INSTALLING YOUR SIROCCO ON A STAND

Wind speed

0 to 31 mph (0 to 50 km/h)

31 to 43 mph (50 to 70 km/h)

43 to 62 mph (70 to 100 km/h)

(60 cm)

Load

Recommandation

79 lbs (3 x 26.5 lbs)

159 lbs (6 x 26.5 lbs) OR guy ropes

159 lbs (6 x 26.5 lbs) AND guy ropes

Fig. 5

20 in

(50 cm)

Load