Airstar SIROCCO REDTECH 700 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Освітлювальне обладнання Airstar SIROCCO REDTECH 700. Airstar SIROCCO REDTECH 700 8 сторінок.

Друкувати сторінку

Make sure there is sufficient space in the installation area to allow the balloon to be inflated and to prevent the product from

tipping over when inflating.

NOTE:

•

Always use AIRSTAR-approved stands designed to work with your Sirocco unit.

•

Always securely tighten all T-Handles to avoid injury.

•

Stands are designed for vertical mounting of Sirocco units ONLY.

⇒ Unfold the stand.

⇒ Lock the base in place.

⇒ On the optional stand P500AH (Fig. 4), lift the outer cylinder at the base slightly, then hook the oval locking ring over the safety

hook.

⇒ On the optional stand P500TA, slide the stand legs out from the folded position until the support bars are exactly horizontal.

⇒ On the P500AH (Fig. 4), weights must be placed on each foot at 24 in (60 cm) from the center of the stand.

⇒ On the P500TA (Fig. 5), weights must be placed on each support at 20 in (50 cm) from the center of the stand.

⇒ Follow this correlation table (indicative for a flat floor and a steady wind)

⇒ Guy ropes are the only way to ensure the safety of the light stand in strong or gusty wind.

⇒ In the case of an uneven surface or sloping ground, the stand column must remain vertical and the tripod legs must rest on a

solid surface.

Fig. 4

24 in

Load

18-07-2022 / A-00222-A

INSTALLING YOUR SIROCCO ON A STAND

Wind speed

0 to 31 mph (0 to 50 km/h)

31 to 43 mph (50 to 70 km/h)

43 to 62 mph (70 to 100 km/h)

(60 cm)

Load

Recommandation

79 lbs (3 x 26.5 lbs)

159 lbs (6 x 26.5 lbs) OR guy ropes

159 lbs (6 x 26.5 lbs) AND guy ropes

Fig. 5

20 in

(50 cm)

Load